Rainfresh CAFO 948 Installation & operation manual - page 7
7
START UP & PROGRAMMING
The control valve is controlled with simple, user-friendly electronics
displayed on an LCD screen.
When power is connected, the screen will show the following information in
sequence:
1. Date & Time
2. Regeneration Days (Time interval between
regenerations)
3. Remaining Days (days left before regeneration
begins)
4. Regeneration Time (Time of day when regeneration
starts)
5. Last Regeneration Date (Last date when system
regenerated)
6. Current Flow Rate (GPM) (flow rate of water being
currently used)
7.
Peak Flow Rate (GPM) (Max recorded flow rate of
the water)
The control valve has a display screen and 4 buttons
PROGRAMMING YOUR CAFO948 FILTER
The valve has 2 levels of programming – Level 1 and Level 2.
The unit is factory set for your use and you do not
need to change any settings other than time and date. Please call Rainfresh before attempting to change
any values as that can affect the performance of your unit.
Level 1 PROGRAMMING
STEP 1 : Set Current Time
1. Press “ ” (MENU) for 3
seconds to unlock screen.
MENU BUTTON
“
”
The function of this key is to enter the
level one programming mode where
the valve settings can be adjusted.
SET / REGEN BUTTON
“
”
This button has two functions. The first is to initiate a manual regeneration by holding
the button for 3 or more seconds. The second function is while in programming mode,
pressing this key allows the user to change the value of each setting.
UP / DOWN
“
”
These buttons are used to increase or
decrease the value of the settings while
in the programming mode.
FOR VIDEO INSTRUCTIONS ON
PROGRAMMING
Visit our website
http://rainfresh.ca/how_to_videos.php
JAN/21/2015
05:27 PM
2. The display will read “Press
MENU Key for 3 sec to
unlock”.
3. After 3 seconds, the display
will beep confirming unlock
4. Press “ ” (MENU) again
and the hour value
becomes highlighted
PRESS MENU KEY
3 SEC TO UNLOCK
CURRENT TIME
05
: 27 PM