Raisecom RC315 User Manual - 7. Dip-Switch Configuration
Raisecom Technology Co., Ltd.
7. DIP-switch Configuration
RC315/316-FE series media converter has an 8-bit dip-switch SW4. The functions for
each bit are as follows in sequence: auto-sensing enable/disable, bit-rate 100M/10M, full
duplex/half duplex, vacant (reserved), fault-pass-through disable/enable, frame length
1916 bytes/1536 bytes, and module type configuration.
7.1. Explanation for SW4 Setup:
Switch
Contents
Status
Configuration Details
ON
RJ45 is configured as manual setup
1
RJ45 auto-sensing or manual setup
OFF
RJ45 is configured as auto sensing
ON
RJ45 manual setup: bit rate is 10M
2
RJ45 manual 100M/10M setup
OFF
RJ45 manual setup: bit rate is 100M
ON
If RJ45 manual setup: Half duplex
If RJ45 auto-sensing: Auto-negotiation fails, working
on half duplex mode
3
RJ45 manual setup:
Full Duplex/Half Duplex
OFF
If RJ45 manual setup: full duplex
If RJ45 auto-sensing: Auto-negotiation fails, working
on full duplex mode
4 Vacant
(Reserved)
ON
Enabled: If the optical link is disconnected, the RJ45
interface will be disabled
5 Fault-pass-through
disable/enable
OFF
Disabled: host RJ45 will always work
ON
Over-sized frame up to 1536 bytes
6 Over-sized
frame
configuration
OFF
Over-sized frame up to 1916 bytes
Note: When SW4-1 is OFF (auto-sensing status), SW4-2 and SW4-3 will be disabled.
SW4-7, SW4-8 are used to set up module types (it is prohibited for end-users to alter
configuration). See the following table:
SW4-7 SW4-8 Module
Types
OFF ON RC315/316-FE-S1
7.2. Factory Default Setup for SW4
1 2 3 4 5 6 7 8
On
Off
█
█
█
█
█
█
11