Rakk dac raleigh audio k&k audio rakk dac mark ii usb to spdif converter installation manual version 2.0 © 2008 - 2011 raleigh audio.
Kit version use this manual with the miniusb version 1.0 of the usb to spdif converter. Required tools and supplies 35 to 50 watt soldering iron diagonal cutting pliers long-nose pliers wire stripper solder warnings and cautions caution – use only solder that is intended for electrical circuits. Do ...
Table of contents introduction ................................................................................................................................................................... 3 assembly instructions ....................................................................................
Introduction the rakk usb to spdif converter is based on the minidsp streamer, which we have adapted for use with the rakk dac. The usb to spdif converter is intended to be used in conjunction with the rakk dac mark iii digital board or other dac that has an spdif input. For the best performance pos...
Assembly instructions ———————————————————————————— the usb to spdif converter digital board is provided completely assembled. However, a transformer must be installed on the rakk dac. Install a lundahl ll1572 in the location on the rakk dac that you have chosen to support the usb to spdif interface....
Installation instructions ———————————————————————————— the rakk usb to spdif board is intended to be mounted to the back panel of the enclosure. These instructions assume that the usb to spdif board will be used with the rakk dac mark iii. The connection between the rakk dac and the usb to spdif boa...
Refer to the diagram below for connections between the rakk usb to spdif board and its power supply. ———————————————————————————— 5. Install the red/black twisted pair. Solder the red wire to pad 10 and the associated black wire to pad 7 on the usb to i2s board. ———————————————————————————— 6. Solde...
9. Refer to the grounding section below and, if needed, install a wire between the (–) pad of the power supply and the chassis at the point where the green-wire safety ground is connected to the chassis. ———————————————————————————— 10. Mount the boards in their locations and secure them in place. —...
8 document version history version description 1.0 original document 2.0 (this document) original supporting the minidsp version of the usb to spdif convertor.
