Raleigh Audio RAKK dac Mark II Installation Manual - page 7
Refer to the diagram below for connections between the RAKK USB to SPDIF board and its
power supply.
————————————————————————————
5. Install the red/black twisted pair. Solder the red wire to pad 10 and the associated black
wire to pad 7 on the USB to I2S board.
————————————————————————————
6. Solder the other end of that red/black twisted pair to the 5Volt output of the power
supply. Solder the red wire the + pad and the black wire to the – pad.
————————————————————————————
7. Install the violet/black twisted pair. Solder the violet wire to the + pad of the SPDIF OUT
and the associated black wire to the – pad.
————————————————————————————
8. Solder the other end of that violet/black twisted pair to the RAKK dac input that you have
chosen to use. Solder the violet wire the + pad and the black wire to the – pad.
————————————————————————————
6