Ramblewood Green EC2-30 User Manual

Other manuals for EC2-30: User Manual

Summary of EC2-30

  • Page 1

    User manual model: ec2-30 ramblewood green www.Ramblewoodgreen.Com.

  • Page 2: General Information

    General information this appliance is designed for domestic household use. The user manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, and contact ramblew...

  • Page 3

     important: the german shcott ceramic glass is tough; however it is not unbreakable and can be damaged if heavy or sharp objects are placed on top. Do not use the unit if its surface is broken or cracked. You should contact ramblewood green immediately. Specifications product specifications and ele...

  • Page 4: Operation Guideline

    Operation guideline first time use  any film or stickers on the glass surface should be removed before use.  you should switch on one cooking zone at a time, for 5 minutes at maximum level. This will help to remove any odor that exists and evaporate any humidity formed after exit factory. Operatio...

  • Page 5: Installation

    Installation the installation and service must be conducted by a qualified technician, in accordance with national & local regulation. Product dimensions and aperture dimensions: unpacking the appliance when unpacking the appliance please check the following items are contained within the box: 1 hob...

  • Page 6

    O cut a hole in countertop per drawings shown above. O important: you must leave clearance of at least 25 mm between the underneath of the unit and any surface below it.  carefully turn the hob upside down and place it on a cushioned mat.  apply the sealing strip provided around the edge of the ap...

  • Page 7

    (a) clip (b) fixing bracket (c) screw  you should insert a clip (a) into the holes which are located in each corner of the hob.  place the fixing brackets (b) over each hole and clip, and then place a screw (c) through the hole and fixing bracket (b). Tighten the screws slowly. Important: do not t...

  • Page 8

    Replacing the mains supply cable if the power supply cord is damaged, it must be replaced by manufacturer or qualified technician, per national & local safety regulation/guideline.  the main terminal block is located on the underside of the hob and terminals are accessible by removing the terminal ...