Ramblewood Green EC2-30 User Manual

Other manuals for EC2-30: User Manual

Summary of EC2-30

  • Page 1

    User guide ec2-30 ramblewood green www.Ramblewoodgreen.Com 1.

  • Page 2: General Information

    General information this appliance is designed for domestic household use. The user manual contains important product safety & installation information. Your safety is of the utmost importance. Please ensure you read this booklet before attempting to install or use the appliance, and contact ramblew...

  • Page 3

    Cast iron and aluminum cookware with sharp edge may scratch the ceramic surface if they are dragged across it.  important: the german shcott ceramic glass is tough; however it is not unbreakable and can be damaged if heavy or sharp objects are placed on top. Do not use the unit if its surface is br...

  • Page 4: Operation Guide

    Operation guide first time use  any film or stickers on the glass surface should be removed before use.  you should switch on one cooking zone at a time, for 5 minutes at maximum level. This will help to remove any odor and evaporate any humidity formed inside the unit after exit factory. Operatio...

  • Page 5: Installation

    Installation the installation and service must be conducted by a qualified / licensed technician, in accordance with national & local regulation. Product dimensions and aperture dimensions: unpacking the appliance when unpacking the appliance please check the following items are contained within the...

  • Page 6

    O cut a hole in counter top per drawings shown above. O important: you must leave clearance of at least 25 mm between the underneath of the unit and any surface below it.  carefully turn the hob upside down and place it on a cushioned mat.  apply the sealing strip provided around the edge of the a...

  • Page 7

    (a) clip (b) fixing bracket (c) screw  you should insert a clip (a) into the holes which are located in each corner of the hob.  place the fixing brackets (b) over each hole and clip, and then place a screw (c) through the hole and fixing bracket (b). Tighten the screws slowly. Important: do not t...

  • Page 8

    Replacing the mains supply cable if the power cord is damaged, it must be replaced by manufacturer or qualified technician, per national & local safety regulation/guideline.  the main terminal block is located on the underside of the hob and terminals are accessible by removing the terminal block c...