RAMSET 721 Operators Manual And Installation Manual - page 7
Your Ramset Model 721 Tool uses only the Ramset fasteners and loads shown below
or listed for the tool in the Product Catalog.
FASTENERS
FASTENERS / LOADS
FASTENERS / LOADS
7
Never use any other types of fasteners or loads in the Model 721 Tool. Use of other types
of fasteners or loads may cause unintentional load discharge, damage the tool, cause poor
fastening performance, or create a risk of serious injury to the operator or bystanders.
DANGER
LOADS
Ramset .22 cal. CW loads are specially made for use in the Model 721 Tool.
The power level of the load is indicated by
the number marked on each box, the color
of the box, and the color on the tip of each
load. As the number increases, the power
level also increases.
Always perform the center punch test
described on page 3 to test the base material.
Always make a test fastening using the
lowest power level first. If more power is
required to set the fastener, use the next
higher power level until the power level
necessary to drive the fastener is reached.
Ramset CW Load
POWER CATALOG
LOAD
CASE
LEVEL
NUMBER
COLOR
COLOR
2
22CW
Brown
Brass
3
32CW
Green
Brass
4
42CW
Yellow
Brass
.300 HEAD PLASTIC FLUTED DRIVE PINS
.145 Shank Diameter in Shank Lengths from
1/2” to 1-1/2”
.300 HEAD PLASTIC FLUTED DRIVE PINS
WITH 7/8” WASHER
.145 Shank Diameter in Shank Lengths from
1” to 2”
.300 HEAD POWER POINT
PLASTIC FLUTED DRIVE PINS
.150 Straight Shank in Shank Lengths
from 1/2” to 7/8”
.150 /.180 Step Shank in Lengths
from 1” to 1-1/4”
CEILING CLIP ASSEMBLIES
Ceiling Clip with 1” or 1-1/4” premounted
.145 Shank Pin and Ceiling Clip with 1” or
1-1/4” Premounted .150/.180 Shank Pin
1/4” - 20 THREADED STUDS
.145 Shank Diameter in Shank Lengths of 1/2”
and 1” and Thread Lengths of 1/2”, 3/4” and 1”
Maximum overall fastener length is 1-1/2” for
the Model 721 tool.
8 mm HEAD TOP-HAT DRIVE PINS
.145 Shank Diameter in Shank Lengths from
1/2” to 1”
CONDUIT CLIP ASSEMBLIES
For 1/2” and 3/4” Diameter Conduit with 1”
Premounted Fastener