RAMSET 721 Operators Manual And Installation Manual - page 9
TOOL OPERATION
Daily Function Test
Always check the tool first to make sure
that it does not contain a load or fastener.
Test the tool several times by depressing
the muzzle bushing fully on a hard surface
and pulling the trigger. You should hear an
audible click as the firing pin releases. Let
up on the tool and check to be sure that the
barrel has opened to the full open position.
OPERATING THE MODEL 721
1. After checking to be sure that the tool
is not loaded, point it in a safe direction
and snap the barrel open with a quick
downward motion. This action positions
the piston in preparation for the next
fastening. Use the spall guard every
time possible to minimize the risk of
being struck by flying debris.
2. With finger off the trigger, place the
fastener, point out, into the muzzle
end of the tool until the point end is
inside the muzzle. NEVER load a
fastener with your finger on the trigger.
DO NOT use excessive force when
inserting a fastener. STOP immediately
if excessive force is require, inspect
the barrel to find out why the fastener
is not entering the muzzle freely. DO
NOT continue loading unless the
problem is corrected.
3. With the tool pointed in a safe direction
the barrel fully open, and your finger
away from the trigger, make sure the
chamber is clear and insert a load into
the tool chamber. Always start with the
lowest power level. If this load does not
fully set the fastener, try the next higher
power level until the proper power level
is found.
TOOL OPERATING INSTRUCTIONS
TOOL OPERATING INSTRUCTIONS
9
PERFORM FUNCTION TEST WITH
EMPTY, UNLOADED TOOL
SLIDE THE BARREL FORWARD
INSERT FASTENER INTO THE
MUZZLE END OF THE TOOL WITH
THE POINT OUT
INSERT A LOAD INTO INTO THE
TOOL CHAMBER