Ramset gypfast air and gypfast air hd operator’s safety & operating instruction manual danger read and obey all safety and operating instructions before operating tool. Pneumatic fastener driving tool for attaching sheathing to light gauge steel framing.
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 safety precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Warning: when using pneumatic tools, basic precautions should always be followed to reduce the risk of personal injury . Wear eye and hearing protection. Always wear hearing and eye protection devices when you are operating the gypfast air, air hd tool or working in the vicinity of this tool . Also,...
Specifications / air systems specifications / air systems 4 air systems operating air pressure the correct operating air pressure is the lowest compressed air setting that will do the job . Using the tool at a higher pressure than required wastes air, and over stresses the tool . Start at 90 p .S .I...
Tool loading loading and unloading nails 1 . Lay the tool on its right side, exposing the gate latch . 2 . Unlatch and open the gate . Swing open the magazine cover . 3 . Uncoil 3” of nails . 4 . Guide the first nail into the drive raceway while placing the coil of nails into the magazine . 5 . Clos...
Cold weather operating precautions keep the tool in a warm area until you are ready to use it . If the tool is already cold, bring it into a warm area, and allow it to warm up before using it . If you must use the tool in cold conditions, drive several fasteners into a scrap piece of wood at the low...
Ramset warrants that new gypfast air and air hd systems power fastening tools, parts and accessories will be free from defects in material and workmanship for the period shown below . Two-year warranty a two-year warranty will apply to all parts, except those listed below as normal wearing parts, or...
For tool repair service contact your local authorized ramset distributor or to find your nearest ramset tool repair center visit our web site at www.Ramset.Com or call 800-241-5640 concretefasteningsystems glendaleheights,il60139 800-ramset6 (1-800-726-7386) www.Ramset.Com buywithconfidence... Buyfr...
