RAMSET TrakFast TF1100 Operating Instructions Manual - Servicing
SERVICING
13
SERVICING
CLEARING A JAM (continued)
At this point, the jammed fastener should fall
out . If the jammed fastener does not fall out,
carefully remove the fastener taking care not
to damage the Shear Block .
After you have removed the jammed fastener
take the following steps to reattach the
Magazine to the tool:
1 . Use the two guide pins to align the
Magazine at the nose of the tool .
2 . Position the Magazine mounting slot
over the locking knob screw .
3 . Slide the Magazine firmly against
the nose .
4 . Tighten the Magazine Locking Knob
and reload the tool .
DANGER
Make sure Magazine is all the way forward
against the nose and Magazine Locking
Knob is tightened securely before operating
tool . Attempting to use tool with a loose
Magazine may result in loss of fastener
control, damage to tool, or pin discharge
toward tool operator .
If you find that the TrakFast tool’s Fan does
not operate after clearing a jam:
Check the condition of your Battery Cell .
If the Handle LED indicator emits a constant
red glow when depressing the tool, recharge
the Battery .
END-OF-WORKDAY ROUTINE
At the end of each workday, conduct an
end-of-workday routine . These simple steps
are based on maintaining the safety and
operational efficiency of the TrakFast tool .
Before you leave the worksite:
1 . Remove the Battery and store in the tool
case . Always use the TrakFast tool case
for transporting and storing the tool .
2 . Dispose of all empty Fuel Cells . Remember
to dispose of these cells where they
will not be found by children, crushed,
punctured, or burned .
3 . Place the Battery Cell in its Charger only
if it needs charging as indicated by the
red charge light in the handle .
4 . Wipe your TrakFast tool with a clean,
soft cloth .
5 . Check Work Contacting Element to
ensure it is operating freely .
These simple steps will not only ensure that
your TrakFast tool is ready to go to work the
next day, but will also ensure that you get
the maximum efficiency from your tool .
TRAKFAST TOOL ACCESSORIES
A variety of accessories are available for the
TrakFast tool:
• BatteryCells
• ClearSafetyGlasses
• TrakFastToolCharger
Contact your Ramset Distributor Sales
Representative for additional information .
act your Sales Representative immediately .