Ramsey Electronics STC1 Instruction Manual - page 18
STC1
• 18
92. Install R58, a 4.7M ohm resistor (yellow-violet-green).
93. Install C28, a 10uF electrolytic. Orientation!
94. Install R59, a 47K ohm resistor (yellow-violet-orange).
95. Install R62, a 4.7M ohm resistor (yellow-violet-green).
Guess what? we have just completed the limiter circuitry and the peak hold
detectors that let us know when clipping occurs. Now we are on to complete the
remainder of the kit, the 8th order switched capacitor filters.
96. Install R19, a 1K ohm resistor (brown-black-red).
97. Install R44, a 1K ohm resistor (brown-black-red).
98. Install R52, a 10K ohm resistor (brown-black-orange).
99. Install C43, a 10uF electrolytic. In case you forgot, check polarity!
100. Install C11, another 10uF electrolytic capacitor.
101. Install U5, one of the MAX291 8 pin ICs. Make sure all 8 pins are
through the PC board before soldering, and that the part is correctly
oriented.
102. Install C44, a .1uF ceramic capacitor (marked 104 or .1).
103. Install C27, a 100pF ceramic capacitor (marked 101).
104. Install R34, a 15K ohm resistor (brown-green-orange).
105. Install R33, a 47K ohm resistor (yellow-violet-orange).
106. Install R29, a 15K ohm resistor (brown-green-orange).
107 Install C32, a .001uF ceramic capacitor (marked .001 or 102).
108. Install C41, a 10uF electrolytic capacitor. Check the direction of your
installation!
109. Install U3, the other MAX291. Make sure all eight pins are through the
board before soldering, and that the part is installed in the correct direction
in relation to the parts layout diagram.
110. Install C9, a 100pF ceramic capacitor (marked 101).
111. Install R14, a 15K ohm resistor (brown-green-orange).
112. Install C37, a 10uF electrolytic capacitor. Polarity!
113. Install R16, a 47K ohm resistor (yellow-violet-orange).