Ramzey 125GY-3A Owner's Manual - page 14
thoroughly.
the drain plug well.
the
filler cap; add specified lubricating oil.
the
filler cap.
the engine and let is idle for a few minutes, and then stall it. Re-
check the lubricating oil level. Add more oil if necessary. Check that the
oil level is at the upper level mark on the dipstick with the motorcycle
upright on firm, level ground. Make sure there are no oil leaks.
CAUTION
Running the engine with insufficient oil can cause serious engine damage.
NOTE
not add any additive to the lubricating oil.
*When running in
dusty conditions, oil changes should be
more frequently than specified in the maintenance schedule.
*Please dispose of used engine oil in a manner that is compatible with the
environment. We suggest you take it in a sealed container to your local
recycling center or service station for reclamation. Do not throw it in the
rubbish or pour it on the ground or down a drain.
SPARK
PLUG (Fig. 16)
Selection
electrode
Plug recommended:
Center electrode
Check and Replace
the spark plug cap from the spark plug.
any dirt from around the spark plug base.
Remove the spark plug using the plug wrench containing in the tool kit
the electrodes and center porcelain for deposits. erosion or carbon
fouling. lf the erosion or deposit is heavy, replace the plug. Clean a car-
bon or wet-fouled plug with a plug cleaner, or use a wire brush.
the spark plug gap using a wire-type feeler gauge. adjustment is
necessary, bend the side electrode carefully.
The spark plug gap should be
Make sure the plug washer
good condition.
the plug washer attached, turn the spark plug in by hand first to
prevent its threads from being damaged, and then
up
by the
spark plug wrench.
6 Reinstall the spark plug cap.
CAUTION
spark plug must be securely tightened. An improperly tightened
plug can become very hot and possibly damage the engine.
use a spark plug with an improper heat range. Severe engine
damage could result.
disconnecting the spark plug, avoid contaminants entering the
cylinder through the installation hole of the spark plug, or premature
wear on the cylinder and piston may produce.
CLEAR AWAY DEPOSIT CARBON
Clear away deposit carbon around the spark plug
and piston ring, on the piston top, in the piston ring
slot and
chamber regularly.
AIR CLEANER
(Fig. 17)
The air cleaner should be serviced at regular inter-
vals as specified in the Maintenance
Generally. the air cleaner must be cleaned and soaked
in oil at least once every
drive, and more
frequently when riding in unusually wet or dusty
areas. See your dealer for further information.
.Remove the left side cover of the vehicle.
?.Remove the air cleaner housing cover and take
out its filter element.
Fin. 17
Screw
Air cleaner housing
Element
the filter element in clean, nonflammable or high flash point solvent
and let it dry.
Never use gasoline or low flash point solvents for cleaning the air cleaner.
A
fire or explosion could result.
the filter element
gasoline engine oil Class