Randell BC-3 Operator's Manual - page 7
7
D. Installation Checklist
After the final location of the unit has been determined refer to the following checklist prior to start up:
1. Check all exposed refrigeration lines to ensure that they are not kinked, dented or rubbing together.
2. Check that condenser and evaporator fans rotate freely without striking any stationary members.
3. The unit must be properly leveled (see figure A page 10).
4. Plug in unit and turn on the control (see operation section).
5. Refer to the front of this manual for serial number location. Please record this information in your manual on
page 3 now. It will be necessary when ordering replacement parts or requesting warranty service.
6. Confirm that unit is holding temperature.
7. Allow your unit to operate for approximately 15 minutes before putting in food.
Note: All motors are oiled and sealed.
Note: All self-contained models are shipped from the factory with the service valves open ready for operation.
Figure A - Bullet Feet Adjustment
The legs are equipped with bullet-type leveling bolts. Turn bolts
clockwise or counterclockwise until the unit is level (both right to left
and front to back). This can be done by hand or with an open end
wrench.
TEMPERATURE PROBE
The blast chillers come standard with one temperature/product
probe. The probe will be previously calibrated from the factory,
but in time, it may need to be adjusted. If so, call a service
technician and have him/her refer to the Control Programming
section below.
PRINTER OPERATION
All Randell blast chillers (except the BC-3) come with an on board data logging printer. This is a thermal printer
that uses a 3.125" spool thermal paper. The printer records the data that the food probes monitor from inside
the unit in the product pans. The printout will always show the air temperature and at least one product tem-
perature. You will see additional printed temperatures depending on how many probes are hooked to the
control.
LOADING PRINTER PAPER
To load the printer paper, pull the paper cover plate towards you. Remove the old paper spool by lifting upward
and forward. Feed the paper into the slot in the top of the paper housing. After the paper self feeds, return the
spool back into the paper housing and place it on the paper carriage. Push the paper cover back in place.
TIPS
1. After each use, be sure to clean and disinfect the product probes.
2. If the power is lost or the unit is unplugged for an extended period of time, the time and date may have to
be reset. Refer to the control programming section for directions to reset/set the time.