1 mp25 club mixer mic 1 mp25 club mixer mic 2 cue split cue phones booth level level level pan pgm 1 cue pgm 2 pgm 3 zone main pgm 4 flexfx cue cue level level a b post a b post a b post a b contour post mic on talkover flexfx mic on talkover flexfx source d1 a3 a4 p1 a1 a2 source d2 a3 a4 p2 a1 a2 ...
Attention: risque de chocs electrique - ne pas ouvrir risk of electric shock do not open caution to reduce the risk of electrical shock, do not open the unit. No user serviceable parts inside. Refer servicing to qualified service personnel. The symbols shown below are internationally accepted symbol...
Attention: risque de chocs electrique - ne pas ouvrir risk of electric shock do not open caution afin d’éviter tout risque de choc électrique, ne pas ouvrir l’appareil. Aucune pièce ne peut être changée par l’utilisateur. Contactez un sav qualifié pour toute intervention. Les symboles ci-dessous son...
4 mp25 club mixer specifications parameter specification phono/line, aux, flexfx inputs 4 stereo unbalanced rca jacks .....Phono or line level rear panel switch for each phono/line input .....Phono response riaa curve ±1 db, gain = 36 db @ 1 khz .....Max phone input 63 mv @ 1 khz .....Max line input...
5 mp25 club mixer general description meet the rane mp25 mixer, satisfying the audio and ergonomic demands of performing djs, in a 19˝ rack format preferred by nightclubs, with a compact 4u design that drops easily into a mobile rig. It's the same size as a classic rane mm 8z, mp 24 or mp 22 series ...
6 mp25 club mixer there's no “quick start” here, we recommend you read this rela- tively short manual to get all this mixer is capable of. Connecting the mixer leave the power unplugged until everything else is connected inputs phono/line inputs (p1-p4) the mp25 has four stereo phono/line inputs ( p...
7 mp25 club mixer main outs record outs rane corp. Mp25 mic 2 p1 p2 mic 1 l r l r max out db r l r l r l phono ground mic line line phono xlr wiring pin 2 = positive pin 3 = negative pin 1 = ground 100-240 v 50/60 hz 12 watts p3 booth out zone out p4 r r l l r l line phono line phono stereo -24 0 mo...
8 mp25 club mixer mixer controls mic inputs two microphone inputs are fully independent, each with these controls: • level control. • pan the signal from left to right. • high / low 2-band, full-cut tone controls. The range is off to +6 db, with unity gain at 12 o’clock. • flexfx assign takes the si...
9 mp25 club mixer phones the headphone monitor provides stereo or mono split cue operation. • in stereo operation, the pan control pans between stereo cue and the stereo main mix. • in split cue operation, the pan control pans between mono cue in the left ear and mono main mix in the right ear. • in...
10 mp25 club mixer flexfx the flexfx architecture in the mp25 is more powerful than typical effect insert solutions. The architecture includes the flexfx bus, an auxiliary bus routed to the flexfx loop which includes two independent effects inserts. Any combination of pgm 1-4 and mic 1-2 may be rout...
11 mp25 club mixer usb drivers the mp25 includes high-performance, high-stability asio and core audio device drivers. The driver allows audio applications to play and record audio via the mp25’s five stereo playback and six stereo record usb channels. The drivers are designed for incredibly low audi...
12 mp25 club mixer midi channel selection the mp25’s front panel controls are midi enabled. Changes to front panel controls may be sent via midi to audio applications on the computer. By default, the mp25 uses midi channel 1 to send midi messages. However, you can change the output channel number us...
13 mp25 club mixer mic 1 mp25 club mixer mic 2 cue split cue phones booth level level level pan pgm 1 cue pgm 2 pgm 3 zone main pgm 4 flexfx cue cue level level a b post a b post a b post a b contour post mic on talkover flexfx mic on talkover flexfx source d1 a3 a4 p1 a1 a2 source d2 a3 a4 p2 a1 a2...
14 mp25 club mixer faders maintaining the magnetic crossfader there are no electrical contacts to clean! The crossfader in the mp25 is designed with materials highly resistant to corrosion and most chemicals. While the crossfader will handle millions of operations, it may become dirty over time. Bad...
Interconnection-1 introduction this note, originally written in 1985, continues to be one of our most useful references. It’s popularity stems from the continual and perpetual difficulty of hooking up audio equipment without suffering through all sorts of bizarre noises, hums, buzzes, whistles, etc....
Interconnection-2 ground loops almost all cases of noise can be traced directly to ground loops, grounding or lack thereof. It is important to understand the mechanism that causes grounding noise in order to effectively eliminate it. Each compo- nent of a sound system produces its own ground in- ter...
Interconnection-3 the absolute best right way to do it the method specified by aes48 is to use balanced lines and tie the cable shield to the metal chassis (right where it enters the chassis) at both ends of the cable. A balanced line requires three separate conduc- tors, two of which are signal (+ ...
Interconnection-4 another way to create the necessary isolation is to use a direct box. Originally named for its use to convert the high impedance, high level output of an electric guitar to the low impedance, low level input of a re- cording console, it allowed the player to plug “directly” into th...
Interconnection-5 buzzing, there is an incompatibility somewhere in the system’s grounding configuration. In addition to these special cable assemblies that may help, here are some more things to try: 1. Try combinations of lifting grounds on units sup- plied with lift switches (or links). It is wis...
Interconnection-6 figure 4. Interconnect chart for locating correct cable assemblies on the following pages. Note: (a) this configuration uses an “off-the-shelf” cable. Note: (b) this configuration causes a 6 db signal loss. Compensate by “turning the system up” 6 db. To input male balanced xlr ¼" b...
Interconnection-7 10 9 s=shield r=nc t=red s=shield r=nc t=red 8 7 s=shield r=black t=red s=shield r=black t=red male 6 5 3=black black 4 3 3=nc 2=red 1=shield shield shield 2 female 1 3=black 2=red 1=shield male b b b b s=nc r=black t=red s=shield r=black t=red 11 cross-coupled output only: connect...
Interconnection-8 doc 102907 ©rane corporation 10802 47th ave. W., mukilteo wa 98275-5000 usa tel 425-355-6000 fax 425-347-7757 web www.Rane.Com 22 21 male (any unbalanced connector) (any unbalanced connector) (check: no standard polarity on euroblocks) (check: no standard polarity on euroblocks) 20...
23 mp25 club mixer how-to properly set mixer level controls correctly setting dj mixer level controls is one of the most important contributors to creating an excellent sounding system. Once you master the fundamental principles you'll know how to get the best possible audio quality from your rane d...
24 mp25 club mixer rane master level controls and master meter levels the main difference djs may notice about the master output level meter is that the master level control has no affect on the meter levels (see above picture). This may seem a bit weird when compared to other dj mixers, but there’s...
· · (signature) january 18, 2011 (date) mukilteo wa, usa (place) compliance engineer (position) declaration of conformity application of council directive(s): 2002/96/ec 2004/108/ec 2011/65/eu manufacturer: rane corporation 10802 47th avenue west mukilteo wa 98275-5000 usa this equipment has been te...
26 mp25 club mixer factory authorized service your unit may someday need to be serviced by the rane factory if you live in the usa. International customers should contact your dealer or distributor for service. You must call the rane factory before shipping. Please do not return your unit to rane wi...
27 mp25 club mixer warranty procedure - valid in usa only notice! You must complete and return the warranty card or register your product online to extend the warranty from 2 years to 3 years! To validate your extended warranty: use the postcard that came in the box with your unit, or go to www.Rane...
Mp25 club mixer.
