Rane SIXTY-EIGHT Operator's Manual - page 2
1
2
3
5
4
6
8
9
0
7
fader asseMBLY reMovaL
1 Remove all five fader knobs.
2 Remove all four screws holding the fader
panel face plate.
3 Lift up the fader panel face plate and set it
aside where it can’t get damaged.
4 Remove the two screws in the main panel at
the top of the fader assembly.
5 Remove the two screws at the front of the
fader assembly.
6 Slide the fader assembly out just enough to
see the three white and blue wires and their
connectors.
7 Unplug the connectors of the three white and
blue wires.
8 Slide out the fader assembly completely.
9 The channel faders are mounted in pairs.
Remove the four screws for each pair of faders
(1 and 2) or (3 and 4).
0 The magnetic crossfader may be removed by
the two screws at each end of the crossfader.
reverse this procedure to re-assemble.
• Plug in all three cables before installing screws.
• Confirm cables are not crossed, with faders 1
& 2 on the left connector, faders 3 & 4 on the
right connector, and the blue crossfader wires
in the center.
• Test all the faders before installing the fader
panel face plate and fader knobs.
RANE SIXTY-EIGHT
FOR
SERATO SCRATCH LIVE •
OPERATOR’S MANUAL
2.1