Rane SIXTY-ONE Operator's Manual - Mixer
Mixer
Controls
Tone Controls
HIGH, MID and LOW full-cut tone controls
adjust the frequency response from off to
+6 dB. Unity gain (no boost or cut) is at 12
o’clock.
Filter
The
FILTER sweeps from Low-Pass to
High-Pass. Set to 12 o’clock for a flat
frequency response. Moving the filter
toward the
LOW position progressively
reduces high-frequencies. Moving the
filter toward the
HIGH position progressively
reduces low-frequencies. The Resonance
or Q of the Filter can be adjusted in the
Setup screen for Hardware: Effects.
See
“Hardware: Effects” on page 36.
FlexFx
The
FLExFx button assigns a PGM channel
to the FlexFx bus where external analog
(with the
AnALOG InsERT button) or software
effects via USB (with the
InsERT
button) may be inserted, such as Scratch
Live DJ-FX.
See “Enable DJ-FX” on
page 39.
The FlexFx loop allows any combination
of
PGM 1, PGM 2, MIc or
AUx to be
assigned to external analog effects or
software effects via USB.
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source >
PGM 2
and select “
3”.
• PH / CD
4 (THRU): Set to PH or cD with the
rear panel switch.
•
When selected in software, this input
is available on USB record 7-8 for use
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source >
PGM 2
and select “
4
”.
• Left Virtual Deck
1 (USB stereo playback
1-2).
• Right Virtual Deck
2 (USB stereo
playback 3-4).
Level
LEVEL controls adjust the input gain from
off to +15 dB. Unity gain (no boost or cut)
is at 12 o’clock.
Pan
Left / Right
PAn controls adjust the balance
of left and right signals. Left and right are
equal at 12 o’clock.
Program Channels
Two Program channels, or buses,
have nearly identical controls with the
exception of the Source selectors.
Source Selector
The
sOURcE selector for PGM 1 selects one
of four sources:
• PH / CD
1 (THRU): Set to PH or cD with the
rear panel switch.
•
When selected in software, this input
is available on USB record 5-6 for use
as the DVS control signal or for audio
recording. To select this control source
in Serato Scratch Live: go to Setup >
Hardware > Control Source >
PGM 1
and select “
1”. See “Control Source”
on page 36.
• PH / CD
2 (THRU): Set to PH or cD with the
rear panel switch.
•
When selected in software, this input
is available on USB record 5-6 for use
as the DVS control signal or for audio
recording. To select this as the control
source in Serato Scratch Live: go to
Setup > Hardware > Control Source >
PGM 1 and select “2”.
• Left Virtual Deck
1 (USB stereo playback
1-2).
• Right Virtual Deck
2 (USB stereo
playback 3-4).
The
sOURcE selector for PGM 2 selects one
of four sources:
• PH / CD
3 (THRU): Set to PH or cD with the
rear panel switch.
•
When selected in software, this input
is available on USB record 7-8 for use
RANE SIXTY-ONE MIXER FOR SERATO SCRATCH LIVE • OPERATOR’S MANUAL 2.4.4
8