Rangemaster 100 Dual Fuel User Manual - page 23
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
21
ArtNo.010-0004 Moving the cooker
ArtNo.105-0010 - 100 Fitting the stability bracket
A
70 mm
C
D
500 mm
B
B
600 mm
ArtNo.010-0010 Lowering the rear rollers (90)
x10
Fig.7-6
Fig.7-7
Fig.7-8
A – Wall face, B – Rear rollers, C – Front levelling feet,
D – Pencil datum line
Fig.7-5
Lowering the Two Rear Rollers
First fit a 13 mm spanner of socket on the hexagonal
adjusting nut (Fig.7-5). Make 10 complete (360°) turns
clockwise (Fig.7-6).
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Completing the Move
Unfold the rear edge of the pack base tray. Open the grill
door and right-hand oven door so that you can get a good
grip on the bottom of the fascia panel as you move the oven
(Fig.7-7).
Carefully push the cooker backwards off the pack base.
Remove the pack base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it.
n
n
Do not use the door handles or control knobs to
manoeuvre the cooker.
Fitting a Stability Bracket
A stability bracket or chain (not supplied by with the cooker)
should be fitted when the cooker is connected to a flexible
gas supply.
When fitting a stability bracket, read these instructions
together with the leaflet supplied with the bracket.
1.
Place the cooker in its intended position and level the
cooker.
2.
Draw a pencil line 70 mm from the front edge of the
levelling feet.
3.
Mark the centre line for the bracket by measuring
600 mm from the left-hand side of the cooker.
4.
Move the cooker forward.
5.
Measure back from the pencil line 500 mm to locate the
front edge of the bracket (Fig.7-8).
6.
Position the bracket so that it is away from centreline of
the cooker to reduce the possibility that it will trap the
electrical connection cable or gas hose.
7.
Fix the bracket to the floor.
8.
Measure the height from floor level to engagement
edge in back of cooker. Add 3 mm to this dimension and
assemble the stability bracket to this height (i.e. from
floor level to underside of the top member), and ensure
the bracket does not foul the oven burner assembly.
Repositioning the Cooker following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.7-7), you need to check behind the cooker to ensure that
the gas hose is not caught.