Rangemaster RMB60HPNGFGL User Manual - Installing The Hob
11
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
Fixing the seal to the back of the hob
The hob must be sealed to the work surface to prevent liquid
from entering into the cabinet. A tape seal is supplied with
the hob.
1.
Turn the hob over and place in on a secure, level surface.
2.
Spread the longer seal
“A”
around the inner left, rear
and right sides as shown in Step 2
3.
With a cutter or scissors cut the excess seal and retain
for next use as shown in Step 3
.
4.
Spread the seal
“B”
around the left. front and right outer
edges of the cooktop as shown in Step 4
.
5.
Spread the seal “
C”
along the rear edge of the cooktop.
Making sure that the beginning and the end overlap at
the seal
“B”
as shown in Step 5
6.
The final result would look like Step 6 as shown in
Fastening the Installation Brackets
Each cooktop is provided with an installation kit including
brackets and screws for fastening the top to fixture panels
from 20 to 40 mm thick.
1.
Turn the cooktop upside down and fasten the brackets
“F”
and
“R”
to the appropriate socket holes, without
tightening the screws
“B”
for the moment as shown in
.
2.
Make sure that the brackets are fastened as shown in
Installing the Hob
1.
Turn the hob back the right way up and position it in
the worktop cut-out.
2.
Insert the cooktop into the hole and position it correctly.
3.
Adjust the position of the brackets
“F”
and
“R”
and
tighten screws the
“Rear Screw”
and
“Front Screw”
to
lock the cooktop firmly in position
.
4.
With a sharp cutter or trimmer knife trim the excess
sealing material around the edge of the cooktop.
Take
care not to damage the workbench.
If the surface that the hob is to be fitted to is tiled or is not
reasonably smooth, additional sealing with a waterproof
silicone sealant may be required.