1. DL manuals
  2. Rapid
  3. Power Tool
  4. 5050e
  5. Operator's Manual

Rapid 5050e Operator's Manual

Manual is about: Electric Stapler

Summary of 5050e

  • Page 1

    Se svenska ............................................................. 1 dk dansk .................................................................. 7 sf suomi ................................................................ 13 de deutsch ..............................................................

  • Page 2

    A b c d e f g a h e f j k fig. 7 fig. 1 fig. 2 fig. 5 fig. 6 fig. 3 m n fig. 4 l d b c.

  • Page 3

    31 gb introduction this operator’s manual describes the rapid 5050e and 5080e. Read the operator’s manual carefully before using the machine. The manual contains safety regulations and descriptions of checks on parts which are critical for safety, together with directions for the correct use and mai...

  • Page 4

    32 gb symbols on the machine see figure 1. A forbidden to put fingers underneath the visor. B rating plate with the following data: manufacturer. Type designation of machine. Serial number. Adapter. Max. Number of staples per minute. Marking for type approval. Ce mark for compliance according to eu ...

  • Page 5

    33 gb accessories pedal intended for trigging the stapling. When the pedal is connected, the internal trigger is disabled. Support table for the object to be stapled. Installation the rapid 5050e/5080e is installed as follows: 1 position the machine on a stable horizontal surface. The machine shall ...

  • Page 6

    34 gb stapling stapling is performed as follows: 1 check that the lever (k) is adjusted for the correct stapling depth. 2 connect the machine to the electrical supply. The warning light (h) will show green. Warning: only the stapling object is allowed to be placed under the visor. 3 move the staplin...

  • Page 7

    35 gb trouble shooting staples not bent sufficiently if the staple is insufficient bent or is folded over the object to be stapled, the following faults can have arisen: - stapling object too thick. At least 3 mm of the staple legs must penetrate through the object to ensure satisfactory results. - ...

  • Page 8

    36 gb technical specification complete designation rapid 5050e rapid 5080e width 120 mm 120 mm length 245 mm 245 mm height 157 mm 160 mm weight 2,2 kg 2,2 kg max. Capacity (80g copying paper) 50 sheets 80 sheets max. Stapling depth 50 mm 50 mm staple cassette type see the front of the cassette no. O...

  • Page 9

    Isaberg rapid ab box 115 s-330 27 hestra sweden.