Rapid 7500 136 Installation, operation & service manual - Danger
7500-S
ERIES
I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
106 of 143
SECTION 16: START-UP PROCEDURES
Electrical Shock Hazard
Disconnect electric before service.
More than one disconnect switch may be
required to disconnect electric from
equipment.
Equipment must be properly grounded.
Severe Injury Hazard
Do not enter equipment while in operation.
Equipment may start automatically.
Do not operate with door open.
Installation, operation and service must be
done by a trained technician only.
DANGER
Failure to follow these instructions can result in death, electrical shock or injury.
Falling Hazard
Use proper safety
equipment and practices to
avoid falling.
Do not use any part of
equipment as support.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
Burn Hazard
Allow equipment to cool
before service.
Internal components of
equipment may still be hot
after operation.
Explosion Hazard
Leak test all components of
equipment gas/oil piping
before operation.
Gas/oil can leak if piping is
not installed properly.
Do not high pressure test
gas/oil piping with
equipment connected.