Rapid Electronics 400S Owner's Manual - page 7
. .
.
.
9
8
OPERATION
3. After the 30-second timer has elapsed, the security system will
automatically ARM. The siren will [1] chirp and the parking lights
will flash [1] time and remain ON for 10 seconds.
PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after the passive arming cycle
has been completed.
PASSIVE ARMING BY-PASS: While the system is disarmed, press the
button twice, the system will respond with [1] chirp and the LED will
turn ON. The security system will remain in this temporary state until
exited. To exit Passive By-pass, press the transmitters or buttons
and the system will return to normal status.
OPERATION
H. ACTIVE DISARMING UNLOCK AND DISARM:
1. Press the button on the transmitter.
2. The siren will chirp [2] times and the parking lights will flash [2]
times indicating that the security system is now Disarmed.
3. The vehicles doors will unlock and the dome light will turn on for 30
seconds upon disarming.
TAMPER DISARMING: If the alarm is triggered, upon disarm of the system,
the siren will chirp 4 times and the parking lights will flash 3 times.
PATHWAY ILLUMINATION: This feature turns the parking light ON for
30 seconds upon an unlock signal and for 10 seconds for a lock signal.
Two Step Door Unlock: This feature will independently unlock the drivers
door only when disarming the security system. Pressing the button a
second time within 3 seconds will unlock the other doors.
Automatic Rearm: If this feature is selected, the security system will
automatically re-arm itself in 60 seconds after disarming with the remote
transmitter. Automatic Rearm will cancel if any door is opened
before the 60 second timer has elapsed.
I. DISARMING WITHOUT A TRANSMITTER
Overriding the Alarm without a Password Pin Code: (Factory Default
Setting)
The Override function may be used if the remote transmitter is lost or
inoperative.
1. Enter the vehicle and turn the ignition switch to the ON position.
(The alarm will sound.)
2. Within 10 seconds push and release the valet/program switch. The
alarm will stop sounding and enter the disarm mode. You can now start
and operate the vehicle normally.
Override the Alarm with Password Pin Code: (See Alarm Feature IV-
2 Programming.)
Unlike the valet switch easily found and defeated, this security system allows
the consumer to program a password pin code. This feature will offer a
higher level of security protection
To Operate Password Pin Code:
1. Enter the vehicle and turn the ignition switch to the ON position.
(The alarm will sound.)
2. Within 5 seconds, enter your chosen first digit code by pressing and
releasing the valet/program switch.
3. Within 15 seconds of the last digit code enter (the 1st code), turn the
ignition switch OFF and then back to the ON position.
4. Within 15 seconds, enter your chosen second digit code by pressing
and releasing the valet/program switch.
5. Turn the ignition switch to the OFF position. [4] Chirps from the siren
or horn and [3] flashes from the parking lights will indicate the system
was disarmed.
Example: To Override the System with the Password Code 83, you
would;
1. Enter the vehicle and turn the ignition switch to the ON position.
(The alarm will sound.)
2. Within 5 seconds, press and release the valet/program switch 8
times.
3. Within 15 seconds of the last digit code enter, turn the
Ignition switch from Off to ON.
4. Within 15 seconds, press and release the valet/program switch 3
times.