Raritan EMX Quick Setup Manual - page 8
EMX Quick Setup Guide
8
QSG-EMX-1A-v3.3.10-E 255-80-6106-00 RoHS
To set
Use this command
Static IPv4 or
IPv6 address
network
address
syntax similar to the example below.
Example:
192.168.7.9/24
Static IPv4 or
IPv6 gateway
network
IPv4 or IPv6
primary DNS
server
network dns firstServer address> IPv4 or IPv6 secondary DNS server network dns secondServer address> IPv4 or IPv6 third DNS server network dns thirdServer address> Commands for wireless networking: General wireless settings: To set or enable Use this command Wireless interface network wireless enabled true , or false SSID network wireless SSID BSSID network wireless BSSID none 802.11n protocol network wireless enableHT true , or false Authentication method network wireless authMethod psk or eap PSK network wireless PSK
EAP outer authentication network wireless eapOuterAuthentication PEAP To set or enable Use this command EAP inner authentication network wireless eapInnerAuthentication MSCHAPv2 EAP identity network wireless eapIdentity authentication EAP password network wireless eapPassword When prompted to enter the password for EAP authentication, type the password. EAP CA certificate network wireless eapCACertificate When prompted to enter the CA certificate, open the certificate with a text editor, copy and paste the content into the communications program. The content to be copied from the CA certificate does NOT include the first line containing "BEGIN CERTIFICATE" and the final line containing "END CERTIFICATE." If a certificate is installed, configure the following: Whether to Use this command Verify the certificate network wireless enableCertVerification true or false Accept an expired or not valid certificate network wireless allowOffTimeRangeCerts true or false Make the connection successful by ignoring the "incorrect" system time network wireless allowConnectionWithIncorrectClock true or false Wireless IPv4 / IPv6 settings: Commands for wireless IP settings are identical to those for wired networking. Just replace the variable word 'wireless'. The following illustrates a few examples.