Raritan KX II Quick Setup Manual - page 5
Dominion KX II Quick Setup Guide
5
QSG-DKX2-v2.6.0-0O-E 255-62-4022-00-RoHS
Assign KX II a Device Name
Choose Device Settings > Network. The Basic Network
Settings page opens.
1
Specify a meaningful Device Name for your KX II
device.
Up to 32 alphanumeric and valid special characters,
no spaces between characters.
Configure the IPv4 Settings
In the IPv4 section, enter or select the appropriate IPv4-
specific network settings.
1
Enter the IP Address, if needed.
The default IP address is 192.168.0.192.
2
Enter the Subnet Mask.
The default subnet mask is 255.255.255.0.
3
Set up your IP Auto Configuration by selecting - None
or DHCP
A
None - for a static IP. Default selection.
Recommended option.
If None is selected, you must manually specify the
network parameters by entering the Default Gateway.
Leaving the selection set to None -
Lets you set the network parameters since KX II
is part of your network infrastructure and you
most likely do not want its IP address to change
frequently.
Ensure redundant failover capabilities should the
primary Ethernet port or the switch/router to which
it is connected fail.
If a failure occurs, KX II fails over to the
secondary network port with the same IP address
so there is no interruption.
B
DHCP - with this option, the IP address is
automatically assigned by a DHCP server.
Dynamic Host Configuration Protocol is used by
networked computers (clients) to obtain unique IP
addresses and other parameters from a DHCP server.
Enter the Preferred DHCP Host Name if DHCP is
selected from the IP Auto Configuration drop-down.
Up to 63 characters.