Rasmussen DFC18-DFC1-R-N Assembly, Installation And Operation Instructions

Summary of DFC18-DFC1-R-N

  • Page 1

    Aga "chillbuster i" 12028 e. Philadelphia st. Whittier , ca 90601 u.S.A. (562) 696-8718 fax (562) 698-3510 e-mail: gaslogs@riwinc.Com web http://www.Riwinc.Com cb-1 2-03 a s s e m b l y , i n s t a l l a t i o n , a n d o p e r a t i o n instructions for rasmussen "single burner" manual, switch, or ...

  • Page 2

    All applications (vented and vent free operation) important notice • due to high temperatures, the appliance should be located out of traffic and away from furniture and draperies. • children and adults should be alerted to the hazard of high surface temperature and should stay away to avoid burns o...

  • Page 3: Vented Operation

    All applications (vented and vent free operation) 9. The chillbuster and its individual shutoff valve must be disconnected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kpa). The chillbuster must be isolated from the gas sup...

  • Page 4: Vent Free Operation

    Vent free operation provisions for adequate combustion and ventilation air this heater shall not be installed in a "confined" space or unusually tight construction unless provisions are provided for adequate combustion and ventilation air. Confined or unconfined space determination: the national fue...

  • Page 5: Vent Free Operation

    Vent free operation combustion air calculations worksheet 1 . Room width length height w x l x h=vol. (ft3) 1 a . 1 b . 1 c . 1 d . 2 . Total volume (ft3 )sum of volume (ft3) of all rooms (sum lines 1a. Thru 1d.) 2 . 3 . Max supportable btu/hr=total volume (ft3) ÷ 50 x 1000 (line 2 ÷ 50 x1000) 3 . 4...

  • Page 6: Vent Free Operation

    Vent free operation fireplace hoods a fireplace hood deflects heat away from the fireplace face and mantel, reducing the potential for heat related warping or discoloration. The use of a fireplace hood is highly recommended. Fireplace hoods are offered by many leading fireplace manufacturers. Mantel...

  • Page 7

    All applications (vented and vent free operation) log placement c1a, c1c, c1b, and c1d 1. 18" sets have 5 logs. 24" sets have six logs. 2. Place largest log (front log) in the front of the grate and the second largest log (rear log) on the rear of the grate behind the locator pins. (figures 5 and 6)...

  • Page 8: . . .

    All applications (vented and vent free operation) dfc1 and dfc1c (double face) log placement (continued): front logs v . Large top log . V large top log . V v . . V v v v small top logs small top logs v v v v log grate guide figure 7 top view front view top logs small front log front log top logs sm...

  • Page 9

    All applications (vented and vent free operation) millivolt pilot lighting (continued): 6. Press piezo ignitor button to light pilot. Continue to hold in the gas cock dial until the pilot flame remains lit when knob is released (approximately 60 to 90 seconds). If pilot does not remain lit, repeat s...

  • Page 10

    All applications (vented and vent free operation) pilot adjustment and operation: the pilot flame should be steady and soft blue surrounding 1/8 inch of the thermocouple tip as shown in figure 15. Op america standard (manual models): 1. To adjust, insert a narrow long stem screw driver throughpilot ...

  • Page 11: (Manual, Switch Or Remote)

    How to order parts parts can be ordered through the supplier from whom you purchased your chillbuster. When ordering parts, always specify (from information available on name plate attached to grate) the following: 1. Model number of the chillbuster. 2. Serial number of the chillbuster. 3. Type of g...

  • Page 12

    Two year consumer product warranty the following warranty has been drafted to comply with the magnuson-moss warranty act applicable to products manufactured after july 4, 1975. It replaces and supersedes any warranty in this package or in any printed literature. Limited warranty: rasmussen iron work...

  • Page 13

    Cpw-cb-2-96 changes (next) page 1: standard update z21.11.2a 2001 due 4-03; standard update z21.11.2b 2002 due 12-03 13.