Rasmussen F Owner's Manual

Other manuals for F: Installation Instructions Manual
Manual is about: Rasmussen Flaming Ember Burner

Summary of F

  • Page 1

    1 report # 10-38 flaming ember burner owner’s manual general assembly, installation, and operation instructions. If using the “ easy” safety pilot system consult separately attached instructions. Register your purchase at www.Rasmussen.Biz. Compliant with the department of building and safety, rule ...

  • Page 2

    2 warning! Check for proper venting a properly sized, unobstructed chimney will normally vent all products of combustion. Any odor or smoke detected inside the room is an indication that the flue is not functioning properly. Shut off the burner immediatley! The cause of the venting problem must be d...

  • Page 3

    3 14 a. B. C 17 1 4 7 6 5 3 2 10 parts list (parts not shown to scale) all flaming ember burners will include the parts listed below except where otherwise noted. The quantity and/or size of parts and supplies shown will vary with each style burner and control. Required tools and materials adjustabl...

  • Page 4

    4 18" 16" 13" 24" 18" 7" 39 sq in. 43,000 27,000 20" 16" 13" 26" 20" 7" 39 sq in. 56,000 35,000 24" 16" 13" 30" 24" 7" 51 sq in. 72,000 37,000 30" 16" 13" 36" 30" 8" 64 sq in. 75,000 50,000 minimum fireplace requirments the minimum permanent chimney or damper opening is the minimum permanent free op...

  • Page 5

    5 warning! Check for proper venting a properly sized, unobstructed chimney will normally vent all products of combustion. Any odor or smoke detected inside the room is an indication that the flue is not functioning properly. Shut off the burner immediately! The cause of the venting problem must be d...

  • Page 6

    6 b) burner pipe ember burners d) 3/8 orifice holder c) orifice spud a) burner plug figure 4 e) flared end f) rating plate/ heat shield step three: burner pan assembly natural gas models; f, fh, fx and fxh (all other models refer to supplied instructions) note: if fittings do not come pre-wrapped wi...

  • Page 7

    7 d) orifice holder a) 1/2’ fip x 3/8” flared elbow (fx18 burner pan used for example) figure 6 burner plug step four: gas supply connection for standard match lighted (cont’d) optional accessory match lighted with manual “v-17” valve (natural gas models only) step three: burner pan assembly note: i...

  • Page 8

    8 figure 8 step four: gas supply connection (ensure that gas supply to fireplace is off) note: if fittings do not come pre-wrapped with teflon threaded tape, pipe compound must be applied to all tapered pipe threads (except in #3 of step 3) to prevent gas leaks. Do not use teflon tape or pipe compou...

  • Page 9

    9 wireless on/off remote with thermostat (thr-2r) wireless wall thermostat (ts-2r) wireless wall switch (ws-2r) wireless wall timer (up to 120 minutes) (wt-2r) wireless on/off remote (sr-2r) warning: an “easy” safety pilot must be installed on all units designed or converted to burn propane gas. The...

  • Page 10

    10 white sand figure 10 a) ember boosters 1. Completely cover burner pipe and ember boosters (if applicable) with pan medium (figure 10) starting from rear of burner pan and moving toward leading edge. Use entire contents of bag provided, allowing medium to spill over leading edge of burner pan (fig...

  • Page 11

    11 1. Completely cover burner pipe and ember boosters with the provided black volcanic ash (figure 13) starting from rear of burner pan and moving toward leading edge. Use entire contents of bag provided, allowing medium to spill over leading edge of burner pan (figure 14a). If using a propane burne...

  • Page 12

    12 a) figure 16 natural gas burner shown with optional manual v17 valve (figure 16a) and volcanic ash (figure 16b) sprinkled around the outside of the burner pan for a decorative effect. Volcanic ash may also be used to conceal the flex connector (figure 16c). A) manual v17 valve b) volcanic ash emb...

  • Page 13

    13 depending on the log style and size, log sets contain from 6 to 10 individual logs and sometimes pine cones. The largest logs will be the front and rear logs. Some log sets have two separate front logs which simulate a charred/burnt effect between the two halves. (figure 18) place the longest log...

  • Page 14

    14 cut away view showing inlet side of burner under pan medium and ember magic figure 20 step seven: lighting and operation instructions applies to natural gas models f, fh, fx, fxh. All other models refer to supplied instructions. • match lighting with optional accessory v-17 valve 1. Ensure that t...

  • Page 15

    15 proper maintanance • keep the area around the log set clean and clear of debris. • when logs develop soot, turn burner on for 15 minutes then lightly spray soot areas with water. Soot will then evaporate. • periodically examine and clean the venting system. Once every year, a qualified agency or ...

  • Page 16: Consumer Record Card

    16 limited warranty: rasmussen iron works inc, 12028 e. Philadelphia street, whit- tier california, u.S.A., warrants this gas log set and accessories against defects in materials and workmanship, and suitable for a particular purpose, for a period of: home (non-commercial use): (1) log castings - al...