Rasmussen RMC1E General Assembly, Installation, And Operation Instructions - page 3
3
FIGURE 6
B) VALVE OUTPUT 3/8 FLARED FITTING
A) 10” FLEX CONNECTOR
Connect 10” FLEX CONNECTOR (Figure 6A) between the
flared ends of the VALVE OUTPUT 3/8 FLARED FITTING
(Figure 6B) and the BURNER INPUT 3/8 FLARED 3/8 x
MIP ELBOW (Figure C). Bend the 10” Flex Connector to the
optimum Valve position (forward and to the side of the Burner
pan, low to the floor).
STEP THREE: CONNECT BURNER AND PILOT GAS SUPPLY
(FAX Style Burner with MA2 air mixer attached shown for example)
FIGURE 4 (CXF AND CXFA Burners
Pilot Thermocouple
Assembly
10-32 bolts
FIGURE 5
(TNA / TNA-LP Burners)
10-32 nuts
& bolts
Pilot
Thermocouple Assembly
VALVE INPUT
VALVE OUTPUT
3/8 FLARED FITTING WITH
10” FLEX CONNECTOR ATTACHED
VALVE INPUT 3/8 FLARED FITTING
(Attach to Gas Supply)
PILOT INPUT
C) BURNER
INPUT
3/8 FLARED
x 3/8 MIP
ELBOW