Rasmussen Yellow Flame Owner's Manual - page 6
6
STEP TWO:
Sprinkle a light covering of “ Ember Magic” over the Pan Medium (Figure 8 A and B). Pull apart “Ember
Magic” fiber material to enhance the glowing ember effect. Spread remaining “Ember Magic” around ends of pan to add
to the ember bed appearance. When done the Burner pan should look somewhat like the illustration below.
(See page 8 also)
(Amount supplied will vary with each size and style of burner)
STEP ONE:
Completely cover
Burner Pipe
and
Ember Boosters
with Pan Medium (Figures 6 and 7A) starting from rear
of burner pan and moving toward leading edge. Use entire contents of bag provided, allowing medium to spill over leading
edge of burner pan Figures 6 and 7B. If using a Natural Gas burner (e.g. FX model), the Pan Medium used will be White
Sand as shown in Figure 6. If using a Propane Gas burner (e.g. FAX model), the Pan Medium used will be Volcanic Ash,
as shown in Figure 7. If using a Natural Gas model, the Volcanic Ash supplied can
be used as dressing for the firebox
floor (See page 8).
NEVER
use White Sand inside a propane gas burner.
PAN MEDIUM
WARNING:
NEVER
use White Sand inside a propane gas burner.
FIGURE 6
Natural Gas
FIGURE 7
Propane
A) Natural Gas
B) Propane
FIGURE 8
A) Ember Boosters
A) Ember Boosters
Leading Edge
Leading Edge
WARNING:
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this heater may result in property damage or personal injury.