N56w24720 n. Corporate circle sussex, wi 53089 800-451-1460 262-246-4828 (fax) www.Rathmicrotech.Com www.Area-of-refuge.Com rp8500003a ver. 9 08/17 made in the usa 3 year warranty smartrescue 5 & 10 with hard wired transformer installation & operations manual.
Thank you for purchasing rath’s smartrescue. We are the largest emergency phone manufacturer in north america and have been in business for over 35 years. We take great pride in our products, service, and support. Our emergency phones are of the highest quality. Our experienced customer support team...
Phone connections smartrescue handset ports for optional 2300 sub-master phone battery backup connection power input smartrescue 5 & 10 page 2 n56w24720 n. Corporate circle sussex, wi 53089 800-451-1460 262-246-4828 (fax) www.Rathmicrotech.Com www.Area-of-refuge.Com • either 24vdc or 110/120vac powe...
Page 3 smartrescue 5 & 10 24 volt power supply installation • connect the hot wire of the 120vac to the l screw on the power supply. • connect the neutral wire of the 120vac to the n screw on the power supply. • connect the ground wire of the 120vac to the ground screw on the power supply. • connect...
Page 4 solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # 0 2 5 3 1 4 6 7 8 9 * # solid light: calling blinking light: received 0 2 5 3 1 4 6...
Solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # / = solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # / = solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # / = solid light: calling blinking light: received 0 2 5 3 1 4 6 7 8 9 * # / = soli...
Yellow (pin-1) green (pin-2) red (pin-3) black (pin-4) handset connection dedicated analog phone line 24v power input battery backup optional sub-master phone ports rj-1 1 0 2 5 3 1 4 6 7 8 9 * # + - to 24v power pin-2 pin-3 1 pair to telco +v -v l n ground neutral 120vac hot transformer included pa...
Page 7 programming options for smartrescue 1. Program smartrescue to allow emergency phones to call it, then outside number(s): programming steps: a. Apply power and backup battery b. Hold down red disconnect and submaster 1 buttons for 5 seconds c. Release buttons (you will hear a confirmation tone...
Page 8 programming options for phone(s) 1. To program phone(s) to dial standard emergency numbers: programming steps: a. Press enter to get into program mode b. Press 1, enter, (phone number), stop press 2-5, enter, (phone number), stop (for each additional phone number) c. Press and hold stop for 2...
Page 9 operation 1. Once all connections are made, the following leds should be lit: • power led, located on bottom edge of the face plate, will be constantly lit green. • battery led, located on bottom edge of the face plate, will be constantly lit: • red = low level charge • yellow = mid-level cha...
Page 10 2300-630sm sub-master installation and operation installation: • mount the sub-master to the wall in desired location • run twisted, 24 or 22 gauge, 4 wire cabling (cat5 rating or greater is preferred) to connect sub-master to smartrescue operation: • lift handset • to dial individual phones...
Page 11 troubleshooting problem possible cause & solutions power led is not illuminated: • check to make sure the transformer is connected to a good 120vac power source. If 24vdc powered, check the power supply. • make sure power connection on the circuit board is secure. Battery led is not illumina...
