Rath SmartRescue 10 Installation & Operation Manual - page 8
Page 7
Programming Options for SmartRescue
1. Program SmartRescue to Allow Emergency Phones to Call it, then Outside Number(s):
Programming Steps:
a. Apply power and backup battery
b. Hold down Red Disconnect and Submaster 1 buttons for 5 seconds
c. Release buttons (you will hear a confirmation tone)
d. Press Phone 2 button, then red button, and then the Phone 1 button
e. Press Submaster 2 button, then Submaster 1 button (you will hear a confirmation tone)
2. Program SmartRescue to Allow Emergency Phones to Call Outside Number(s) Only
(Factory Default):
Programming Steps:
a. Apply power and backup battery
b. Hold down Red Disconnect and Submaster 1 buttons for 5 seconds
c. Release buttons (you will hear a confirmation tone)
d. Press Phone 2 button, then Red button, then Submaster 2 button, and then the Phone 5 button
e. Press Submaster 2 button, then Submaster 1 button (you will hear a confirmation tone)
Note: You must program each Emergency Phone after programming SmartRescue.