Ratoc Systems EX30S User Manual - Technical Support
eSATA ExpressCard/34
EX30S
User's Guide
1
2
3
4
5
6
Introduction
* * * 2
-1. Package Contents
* * * 2
-2. Layout
* * * 2
-3. System Requirements
* * * 3
-4. Specifications
* * * 3
-5. Caution
* * * 4
Setup
* * * 5
-1. Installation on Windows System
* * * 5
-2. To Verify Driver Installation (Windows)
* * * 7
-3. Hot-plug tool (Windows)
* * * 8
-4. Installation on Mac system
* * *10
Connecting/Removing eSATA drive
* * *11
-1. Windows
* * *11
-2. Mac
* * *15
Removing ExpressCard
* * *16
-1. How to remove EX30S on Windows
* * *16
-2. How to remove EX30S on Mac
* * *16
Registration & Tech-Support
* * *17
-1. Registration
* * *17
-2. Tech-Support
* * *17
Appendix
* * *18
Contents
-1. Package Contents
Introduction
1
1
-2. Layout
1
eSATA Connector
ExpressCard Connector
Support Port Multiplier)
-3. System Requirements
1
-4. Specification
1
What's Port Multiplier(PM)?
?
..
..
..
.
-5. Caution
1
Setup
2
-1. Installation on Windows system
2
Found New Hardware Wizard
No, not at this time
Next
Install the software automatically(Recommended)
Next
Finish
Windows XP, Server 2003
Silicon Image SiI3132 SATALink Controller
-2. To Verify Driver Installation
2
Silicon Image SiI3132 SATA
Link Controller
What's HotPlug Tool
-3. HotPlug Tool (Windows)
2
Add or Remove Programs
Control Panel
HotPlugTool
Change or Remove Programs
OK
Start Program Hot plug tool
[A] Removing eSATA drive
Stop
[B] Change HotPlug Tool setting
HotPlug Tool Window
SCSI Disk
Device
-1. How to use HotPlug Tool (Windows Only)
3
Connecting/Removing eSATA drive
3
If the system recognizes the eSATA drive, the icon of HotPlug Tool will
Finish
Tool
Registration & Tech-support
5
Install HotPlug Tool
Uninstall HotPlug Tool
-4. Installation on Mac System
2
SiI3132_1.1.6u_Sil_Pkg
-2. Connecting/Removing eSATA drive on Mac
3
Removing ExpressCard
4
Safely Remove Hardware
Silicon Image SiI3132 SATALink Controller
-1. How to remove EX30S on Windows
4
-2. How to remove EX30S on Mac
4
Appendix
Appendix
6
Trademarks
-Windows is a registered trademark of Microsoft Corporation.
-MacOS, PowerMacintosh, PowerBook and Mac logo are registered
trademarks of Apple Computer, Inc.
-Other brand and product names may be registered trademarks or
trademarks of their respective holders.
Regulatory Agency Notice FCC Compliance Statement This equipment
has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible
for compliance may result in this unit not complying with FCC Rules Part 15.
http://www.ratocsystems.com/english/
Software Update and Support
http://www.ratocsystems.com/english/
Technical Support
http://www.ratocsystems.com/english/contact/support.html
18
[A]
[B]
Power off Card
EX3
0S
EX3
0S
EX3
0S
EX3
0S
EX3
0S
EX3
0S