Ratoc Systems MR18 User Manual - page 12
Page.12
●SD Card (For both SD UHS-II slot and SD Card slot)
+
Insert SD card with the SD label facing up.
+
Insert it until it clicks into place.
+
When removing, please push the media again to eject it.
2
-4. Direction of each media insertion
Caution
●Be careful of direction of media insertion when each media is inserted.
●If media is inserted in the wrong direction, media or MR18/MR18EX may have damaged.
SATA
7pin
SATA Power 15pin
Put both
connectors at the
right side and
insert SSD into
the slot slowly.
SSD
SSD Drive
●CF Card
+
Insert CF card with CF label facing up.
+
Insert it firmly.
+
When removing, push the eject switch.
●SSD
+
Set the direction of SSD insertion, as shown in the bottom right.
+
Insert it until some part of SSD goes approx 0.6 inch
beyond the front panel.
+
When removing, pinch the SSD protruding from
the panel and slide it out slowly.
●SxS Card
+
Insert SxS card with SxS label facing up.
+
Insert it until some part of SxS card goes
approx 0.6 inch beyond the front panel.
+
When removing, pinch the SxS protruding from the panel
and slide it out slowly.
0.6 inch