Ratoc Systems MR18 User Manual - page 8
Page.8
2
Set up
2
-1.Procedure to install this product
Connect a USB cable
Set up HotPlug tool
Preparation is complete
2
-2.Connection of a USB cable
2-2-1.Connection of MR18
●It is required to install MR18 into a 5 inch bay of a PC. For further information, please refer to the User’s
Manual which accompanies a PC, PC case.
●Attach the bundled USB cable into the Micro-B connector of MR18.
●Don’t insert the wrong side of the cable forcefully.
●Secure the cable with the fixation band after inserting the cable.
●Insert a USB cable into a USB port of a PC.
USB3.0 port
Fixation band for cable
●MR18
-----------Page 8
●MR18EX-----------Page 9
※
The bundled HotPlug tool is
for the use of Windows only.
For Mac, this tool is not required,
because standard removal tool
in Mac is used instead.
Next page