Ravel REVAC Installation And Operation Manual - page 10
RE/DD/UM/REVAC 1.0-01
Page 10
Alarm DVA
Alarm DVA is selected by pressing the no ‘3 ‘ from the menu
screen. The LCD Display will be shown below.
3. Alar m DVA: D
D
E
D – Disable ; E- Enable
Press Left / Right Key to Enable / Disable the Alarm DVA.
Note:-
If Alarm DVA is in Disable mode, then if any fire is detected
wailing
tone will played
If Alarm DVA is in Enable mode, then if any fire is detected
Recorded Message will played
Program
Access to programming is possible only by Admin password
(Default Password – 54321).
By selecting the number 4 from the menu screen, system enters
into the program mode. We can Record a voice and Erase a
voice in this mode.
A) Record.
By pressing the number 1 from the Program screen, the we can
record a voice. The time delay range is 1 to 60 Seconds. The LCD
Display shows as follows.
1. Re cord
Recor ding...
Time : 020 Se c
B) Erase
By pressing the number 2 from the Program screen, then we can
erase record a voice. The LCD Display shows as follows.