Ravelli o-ring User Manual - page 28
AL 07
RESETTABLE
THERMAL
BREAKER
The manual reset thermostat connected to
the hopper.
Reset the thermostat by pressing the
button on the back of the stove.
Combustion in the brazier is not optimal
due to clogging or obstructions of internal
stove ducts.
Switch off the stove, clean the brazier and
the tube bundle and adjust the combustion
setting the Pellet/Air values.
Contact the Support Service.
AL 08
DEPRESSURIZA-
TION
The flue is blocked.
Check the flue is free and clean.
The vacuum meter is faulty.
Contact the Support Service.
!
EACH ALARM CAUSES THE IMMEDIATE SWITCHING OFF OF THE
STOVE. PRESS THE SWITCH-ON KEY TO RESET THE ALARM. BEFORE
SWITCHING ON THE STOVE AGAIN, CHECK THAT THE SIGNAL HAS
BEEN REMOVED AND THAT THE BRAZIER IS PROPERLY CLEANED TO ENSURE
CORRECT RESTART.
maIntenance
Cleaning should be provided by the user
Before any cleaning operation on the stove, implement the following precautions:
•
switch off the stove and disconnect the power cord with the stove in “Switched
OFF” state;
•
make sure all the parts of the stove are cold;
•
make sure the ash is completely cooled.
!
PLEASE READ CAREFULLY THE FOLLOWING INSTRUCTIONS TO PER-
FORM PROPER CLEANING. FAILURE TO COMPLY WITH THESE IN-
STRUCTIONS MAY LEAD TO MALFUNCTIONS OF THE STOVE.
clean the surfaces
To clean the surfaces of the coated metal parts, use a cloth soaked in water or
water and soap. Attention! Use of abrasive detergents or diluents can damage
the surface of the stove.
Grate cleaning should be carried out before each switch-on
To ensure proper cleaning before switching on the stove, it is necessary to check
that the brazier is clean and so that they are always excellent combustion, thus
avoiding any overheating that may cause changes in the color of the paint or
peeling of the door coating. Furthermore, poor cleaning of the brazier can cause
stove switch-on problems.
Before removing the brazier and check for any dirt inside it, remember to re-
move the “grill brazier”. Once the brazier grill is clean it should be fitted in its
housing ALWAYS AFTER having installed the brazier.
Grate
Housing
Drawer ash
28