1. DL manuals
  2. Ravelli
  3. Indoor Fireplace
  4. Sara
  5. Installer Manual

Ravelli Sara Installer Manual

Other manuals for Sara: Owners And Installation Manual
Manual is about: Wood Pellet Fire

Summary of Sara

  • Page 1

    Economical user friendly leading design healthy home visible fl ame clean air approved sara wood pellet fire registered installer’s manual please read this entire manual before installation and use of this wood pellet fire. Failure to follow these instructions could result in property damage, bodily...

  • Page 2

    Attention if you are a not a registered nature’s flame wood pellet fi re installer, and do not have legitimate access to the necessary passwords to install and program the sara wood pellet fi re, you must not install or attempt to install this fi re. The sara wood pellet fi re requires technical pro...

  • Page 3: Table of Contents

    Table of contents introduction ...................................................1 positioning and installation of the wood pellet fi re ..................................1 positioning ....................................................... 1 installing ................................................

  • Page 4: 1. Introduction

    Page 1 2.1 positioning generally sara should be installed in a centrally located position within the home. When deciding where to position the appliance, you must consider the following: 1. The place of installation of the pellet fi re must comply with local and national regulations. The pellet fi r...

  • Page 5

    Page 2 joints must be riveted using stainless steel rivets. 10. Before connecting the pellet fi re electrically, the connection of the exhaust spigot must be completed (specifi cally for non-aluminium pellet fi res) with the fl ue. (all fl ue joins must be sealed with maniseal exhaust cement). 11. S...

  • Page 6

    Page 3 ecoteck and nature’s flame declines all responsibility deriving from the improper use of the pellet fi re, from its incorrect use by the user, by unauthorised modifi cations and/or repairs or from the use of spare parts which are not original. Ecoteck and nature’s flame declines all direct ci...

  • Page 7: Creating The Cavity

    Page 4 as the sara insert wood pellet fire is typically installed in new homes, it is necessary to build a compliant cavity that will house the fi re and the frame. The front facia of the enclosure must be made of a fi reproof rated board (above 80°c) such as (but not limited to) micore, supalux or ...

  • Page 8

    Page 5 6. Installing into an existing cavity - retro-fi t as the sara insert wood pellet fire is typically installed in new homes, it is necessary to build a compliant cavity that will house the fi re and the frame. The front facia of the enclosure must be made of a fi reproof rated board (above 80°...

  • Page 9: 7. Architectural

    Page 6 7. Architectural drawings 7.1 example of cavity design - section view 1. Angle section for support fi xed to timber frame/fl oor using coach screws or ‘dynabolts’ when fi xing to concrete. 2. The joint for fi re rated board* and plasterboard located over frame member must be stopped to manufa...

  • Page 10

    Page 7 7.2 example of cavity design - t op v iew 1. Angle section for support fi xed to timber frame/ fl oor using coach screws or ‘dynabolts’ when fi xing to concrete. 2. The joint for fi re rated board* and plasterboard located over frame member must be stopped to manufacturer ’s instructions. Not...

  • Page 11: Adjusting The Support Frame

    Page 8 8. Adjusting the support frame the sara wood pellet fire must be installed on the supplied, adjustable support frame. The height of this frame can be set at the home-owner’s desired height, up to a maximum of 530mm. The frame is adjusted by manipulating the bolts, which are located on each of...

  • Page 12: 14. Television

    Page 9 14. Television clearances if electrical equipment (eg plasma tv, lcd tv or home theatre) is to be installed above the wood pellet fi re, we recommend installing a mantle below the tv screen, or recessing the tv screen into the wall, for heat protection. The clearances shown are recommended mi...

  • Page 13: 16. Flueing

    Page 10 16. Flueing each 55 built-in-heater flue kit (non-chimney installation) contains:- this flue kit may be used in new or existing timber chimneys . The overall height of the flue is 3.6m. Kit is supplied in a carton. Note: the davin 55 built-in-heater flue kit (non-chimney) complies with as/nz...

  • Page 14: 17.  Controls and Menus

    Page 11 17. Controls and menus 17.1 description of controls • p1 : button to decrease general values • p2 : button to increase general values • p3 : turns fi re on-off • p4 : button to change ambient temperature • p5 : button to change operating power • p6 : multifunction button • p7 : multifunction...

  • Page 15

    Page 12 5. Set the desired day by using [1] or [2] according to the table shown below. 6. Press [7] to confi rm 7. Time clock will appear on the display and the current time will be shown. Change the hours of the day with [1] or [2] (24 hour clock) example: 4:30p.M would be 16:30 8. Press [7] to con...

  • Page 16

    Page 13 17.3.6 loading the screw (auger) insert models - loading the auger should only be carried out in off mode when the stove is new or the fi re has run out of fuel, the auger will be empty. In this case it may be necessary to ‘load’ the auger so the fi re will start. To load the screw/auger, pr...

  • Page 17

    Page 14 18. Programming & commissioning this section refers to password protected sections of the pellet fi re menus. Only nature’s flame approved pellet fi re installers and technicians will have access to these passwords. If you are not a nature’s flame approved installer or technician, please do ...

  • Page 18

    Page 15 degrees pr37 °c / °f °c blackout pr38 sec 10 re-ignition block pr39 min 4 t-extinction min pr40 min 5 fan 2 threshold pr41 °c - comfort climate pr42 on / off off fan 2 speed - 1 pr43 v - fan 2 speed - 2 pr44 v - fan 2 speed - 3 pr45 v - fan 2 speed - 4 pr46 v - fan 2 speed - 5 pr47 v - draft...

  • Page 19: 19. Technical

    Page 16 19. Technical drawings microprocessor f n fumi scamb. Coc. Acc. Al2 al1 n -tc1+ term. N.Amb. N.H2o n.Pel. Enc +5v gnd blue capacitor red blue black black y ellow/green y ellow/green y ellow/green 7 8 11 12 9 10 3 4 brown brown y ellow/green brown 10 9 brown blue y ellow/green black blue blue...

  • Page 20

    Page 17 20. Producer statement and warranty registration form producer statement & warranty registration form fax to : 03 348 1743 or post to : po box 11-043, sockburn, christchurch 8443 or scan & email to rughuv#qdwxuhvÀdphfrq] product (please tick one) pellet boiler pellet fire apricus solar custo...

  • Page 24

    Inspiring people to love the experience of sustainable wood pellet heat 0800 pellet (0800 735 538) info@naturesfl ame.Co.Nz www.Naturesfl ame.Co.Nz nature’s flame po box 11-043 sockburn, christchurch, nz.