Raveon RV-M7-UC-GX Quick Start Manual - page 9
M7 GX Quick Start Guide
9
Raveon Technologies Corp.
6.5. GPS Additional Commands
The following commands are unique to the –
GX
version of the
M7
.
When you execute any of these commands, the new parameter is
automatically stored in EEPROM.
Command
Command Description
Parameters
Default
ATHX
Singe-hop repeat.
Only applicable if repeater
function is enabled. (ATXR = 1) 0 = repeater
will repeat as programmed . 1 = will not repeat
any packet that has already been repeated.
0 or 1
0
GX
Display GPS settings.
Show an overview of
the current GPS features and configurations in
the M7 GX.
-
-
GPS
GPS Operation Mode.
Read/Set the GX
version’s Operating mode.
0 - 6
1
GPS&F
Reset all GPS (-GX version) parameters.
Set
the GX version’s Operating mode to GPS mode
4, and sets all GPS parameters to factory
defaults. It does not erase frequency or other
radio-related parameters.
-
-
IDLERATE
IDLE TX Interval.
Set the number of seconds
between position transmissions when the unit is
idle (has not moved more than TRIGDX
meters).
0-9999
seconds
10
KEYPHRASE
Privacy Security Key Code.
Set the
privacy key for this device. It must be the
same key as used on all other Raveon
products in your system. It secures radio
transmissions from unauthorized reception.
Set it to 0 to disable security encryption of
data.
2-16
ASCII
character
s.
“RAVE
ON”
PREFIX
ID Prefix.
Set an ID prefix. The prefix is 1-8
characters that will be put in front of the ID
when reporting an ID as a waypoint name. A
dash means no prefix. Default is a capitol letter
V.
1-8 ASCII
characters
Set it to
“0” for no
prefix.
V
PROX
Proximity Alert.
Set a minimum proximity
distance. When any
M7 GX
with properly
configured ID codes and KEYPHRASE comes
within this many meters of this unit, a proximity
warning is triggered. The report interval will be
at the TXRATE setting, and report the proximity
warning at least 8 times or until the distance
between the two
M7 GXs
increases beyond the
PROX distance.
0-9999
0=feature
disabled
Disabl
ed (0)
REPEAT
Enable -GX Repeating.
This simple command
enables the repeater feature of the
M7 GX
, and
configures it for standard operation. The user
may alternately use the ATX and ATRX
commands, but they are more complicated to
use. This command enables the unit to repeat
all messages it receives, as long as the first
digit of the 4-digit ID matches its first digit. (It
0 Off
1 0n
0