Raychem QuickStat-TC Installation & Operation Manual - page 5
Vacation Mode
In this mode, the QuickStat-TC is set to the Vacation setpoint
temperature and will override all programming until Vacation mode is
disabled. To place the QuickStat-TC in this mode:
1. Press the
button, and the
icon appears on the display.
2. To disable Vacation mode, press the Mode/Ret button to change the
mode to Automatic
or Manual
.
To reset the QuickStat-TC to factory default settings:
3. Turn the thermostat to Off.
4. Press the up button and switch the thermostat On.
5. After the thermostat setup is completed, release the up button .
Error Messages
The measured temperature is below the thermostat’s display
range. Heating is activated.
The measured temperature is above the thermostat’s display
range. Heating is deactivated.
Verify the floor sensor connection to the thermostat.
QuickStat-TC Installation & Operation Manual
5
400-115-052