Rayline funtom 2 Instruction Manual - page 13
• If the Li-Po battery suffers an impact, please store the battery for the next 30 minutes
at a safety location. Please make sure if the Li-Po battery blows up or overheated
• Please do not try to manipulate, modify or to repair a Li-Po battery
5A
Turn on the power switch on the aircraft and
place it on the parking apron. When the indicator
light is flashing, please do not move the
Quadrocopter so that the gyro will read the
midpoint
5B
Open the remote control power switch and push
the throttle stick from the lowest to the highest,
and then pulled a minimum of code to complete.
5C
After the flight please turn off the power switch to
avoid excessive battery discharge.
5D
Turn off the transmitter. If transmitter is not to be
used for a long duration, please remove the
battery for storage.
Check if the screws are firmly tightened. Check if transmitter and receiver are fully charged. Take care
of people and obstacles in the near. It is recommended to practice hovering before flying. Please
stand approx. 2 meter behind the Quadcopter. The battery is at a low level if all four lights flashed at
the bottom of the air freight.
1. Once you press (Figure 1) the headless mode button sounds a beep and the four LEDs on the
quadricopter will begin flashing, this means the headless mode is turned on.
Press the button again, an acoustic signal will sound again and the LEDs at Quadcopter lit
continuously, this means the headless mode is off.
2. When the headless mode is turned on, the quadrocopter flies based on the orientation of the
remote control, no matter how it is oriented. It's easy to bring back the copter, if he is far away. After
landing it takes five seconds until the sensor has reset. The four status LEDs at the bottom of the
Quadrocopter glow permanently and then is switched to the normal mode.
3. When starting the remote control should be directly behind the Quadrocopter. The on / off switch
of the Quadrocopter should directly point to you, as can be seen in Figure 2.
1. Controller
5.
Flying preperation
6. Operating
7. Headless Mode
2A: 3D Everson ● 2B: left control lever ● 2C: Turn leftFine-Tuning ● 2D:Turn right Fine-Tuning ●
2E:Power Indicator ● 2F: Left/Right Fine-Tuning ● 2G: Backward Fine-Tuning ● 2H: Automatic
cruise ● 2I:Forward Fine-Tuning ● 2J:Right control lever ● 2K:High/Low speed switch ● 2L:On/OF