Raymarine LifeTag System Operating Manual - page 4
2
LifeTag System Operating Guide
If a Tag is not active,
press and release the
pushbutton to activate
the Tag.
2. Ensure Tags are Active
1. Apply power to Base Station
Base Station
Getting started
Before issuing Tags to crew members, check each Tag to
ensure the LED indicator briefly flashes GREEN once every
10 seconds. This indicates that the Tag is ACTIVE.
If the indicator shows any other indication, check below to determine what to do.
12 V dc
Check that the Alarm 'chirps'
briefly, as power is applied
D884-1
3. Issue Tags to crew
What to do if an alarm occurs
How to carry Tags
What will initiate an alarm
How to know if a Tag is active
How to know when a battery needs changing
Issue Tags to your crew members, then instruct them how to use the LifeTag system.
Color
Action
Meaning
Searching for Base Station. Wait for a few seconds. If
normal operation does not start, check that the Base
Station is switched on.
Normal operation. The Tag is ready for use.
Continuous half-second flashes
every second
Two flashes once every 10 seconds
Continuous alternating flashes
Brief flash once every 10 seconds
GREEN
GREEN & RED
RED
RED
Low battery. Replace the battery as described in this guide.
Tag LED indications
D8985-1
Alarm indication. Carry out the Man Overboard procedure.
Continuous brief flashes
RED
Tag is de-registered.
81275_1.book Page 2 Thursday, April 6, 2006 2:35 PM
Draft copy 06/04/06