Raymarine RAY50 Mounting And Getting Started - page 12
Dxxxxx-1
1. Check the selected location for the unit. A clear,
flat area with suitable clearance behind the panel
is required.
2. Fix the supplied mounting template to the selected
location, using masking or self-adhesive tape.
3. Using a suitable hole saw (the size is indicated on
the template), make a hole in each corner of the
cut-out area.
4. Using a suitable saw, cut along the inside edge of
the cut-out line.
5. Ensure that the unit fits into the removed area and
then file around the rough edge until smooth.
6. Drill 4 holes as indicated on the template to accept
the fixings.
7. Remove the backings from the supplied gasket.
8. Place the gasket in position on the back of the unit
and press firmly onto the flange.
9. Connect the power, and other cables to the unit.
10. Slide the unit into place and secure using the fixings
provided.
11. Attach the front bezel.
Note: The supplied gasket provides a seal between
the unit and a suitably flat and stiff mounting surface
or binnacle. The gasket should always be used.
It may also be necessary to use a marine-grade
sealant if the mounting surface or binnacle is not
entirely flat and stiff or has a rough surface finish.
Attaching the front bezel – Ray60 / Ray70
After installation the front bezel can be attached
following the steps below.
The following procedure assumes that the unit has
already been mounted in position.
1. Orientate the bottom-right side of the bezel under
the bottom-right side of the unit, ensuring that the
clips along the bottom edge of the bezel latch into
position.
Dxxxxx-1
2. Ensure the bezel is correctly aligned with the unit,
as shown.
3. Apply firm but even pressure to the bezel along the:
i.
Outer edges - work from the sides upwards and
then along the top edge, to ensure that it clips
securely into position.
ii. Inner edges - ensure that the bezel sits flat.
4. Check that all control buttons are free to operate.
Fistmic / Handset mounting
The Fistmic and optional Handset can be mounted by
following the steps below. Whilst only the Fistmic is
pictured below the steps are identical when mounting
the Handset using the mounting clip.
Before mounting the unit, ensure that you have:
• Selected a suitable location, ensuring there is nothing
behind the mounting surface that may be damaged
when drilling.
• Identified the cable connections and route that the
cables will take.
Dxxxxx-1
0
0
00
1. Check the selected location for the mounting clip,
a clear flat area is required, with sufficient space
around it to place and remove the Fistmic / Handset.
2. Using a pencil, offer up the mounting clip to the
desired location and mark the location of the screw
holes on the mounting surface.
3. Drill the mounting holes using a suitable size drill bit.
4. Hold the clip in place and secure using the screws
provided.
5. Hook the Fistmic / Handset over the clip and gently
push down until it clicks into position.
12
Ray50 / Ray60 / Ray70