Raymarine ST60 Tridata Owner's Handbook Manual - Boat Show Mode
Chapter 4: Calibration
33
Boat show mode
CAUTION:
Do NOT enable this mode. It must only be used for demonstration
purposes.
Ensure that the Boatshow Mode Use is set to bS0 (disabled). If necessary, press
either the
vmg
key or the
tack
key to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
vmg
and
tack
keys to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
If you want to apply the factory defaults, ensure the display shows F1 , but
if you
want to retain the current values,
ensure that the display shows
F0
.
Leaving Dealer calibration
Hold down the
disp
and
true/app
. keys for 2 seconds to save your changes, exit
Dealer calibration and resume normal operation.