Raynor ULTRA 3595RGDS 3/4 HP Owner's Manual - page 28
Smart Control Panel
®
Messages
The following messages are contained within the Smart Control Panel
®
and may appear during the operations of the unit:
Meaning: This message will appear if the safety reversing sensors are
out of alignment, if they are blocked or if the wiring is disconnected. To
clear message from door control do the following:
• Check to see that area is clear between the safety reversing sensors.
• Check to see that the safety reversing sensors are not misaligned.
• Realign receiving eye sensor, clean lens and secure brackets.
• Verify door track is firmly secured to wall and does not move.
•
Check to see that the safety reversing sensors’ wires are connected to the
motor unit.
• If message has not cleared after the above checks, refer to message #2.
Meaning: This message will appear if the Safety Reversing Sensors are
miswired. To clear the message, do the following:
•
Inspect the safety reversing sensor wires for a short (staple in wire), correct
wiring polarity (black/white wires reversed), replace/attach as needed.
• Disconnect all wires from back of motor unit.
•
Remove safety reversing sensors from brackets and shorten sensor wires
to 1-2 feet (30-60 cm) from back of each sensor.
•
Reattach sending eye to motor unit using shortened wires. If sending eye
indicator light glows steadily, attach the receiving eye.
•
Align sensors, if the indicator lights glow replace the wires for the sensors. If
the sensor indicator lights do not light, replace the safety reversing sensors.
Meaning: This message will appear when the ‘LEARN’ button has been
pressed on the door control. Pressing the ‘LEARN’ button again will
allow the user to program an additional remote control to the opener.
Meaning: This message will appear when the ‘learn’ button has been
pressed a second time on the door control or anytime on the opener.
The opener is ready to program another remote control by simply
pressing the remote control button. Once the opener has ‘LEARNED’ the
remote control, the worklight will blink one time.
Meaning: This message will appear when the ‘Lock’ button has been
pressed and held for more than one second. This feature will disable the
opener from receiving remote control signals. To exit ‘LOCK’ mode,
press and hold the button for more than one second.
Meaning: This message will appear when the ‘Language’ button has
been pressed. Pressing the button will toggle to the next language.
Meaning: This message will appear when the Motion Sensing button is
pressed. The motion detector will toggle on or off with each press of the
button.
LEARN REMOTE CONTROL
PRESS LEARN BUTTON TO
CONFIRM
LEARN MODE PRESS
REMOTE CONTROL BUTTON
TO PROGRAM REMOTE
LOCK MODE REMOTE CONTROL
LOCKED OUT PRESS LOCK
BUTTON TO ENABLE REMOTE
SAFETY SENSORS
MALFUNCTION CHECK
MISWIRING SEE OWNER’S
MANUAL
ENGLISH, FRANÇAIS AND
ESPAÑOL
MOTION SENSING ON
MOTION SENSING OFF
SAFETY SENSORS CHECK
ALIGNMENT, BLOCKAGE OR
MISWIRING SEE OWNER’S
MANUAL
Message
Message
Message
Message
Message
Message
Message
28