Ritron “ 6 “ SERIES OUTPOST Owner's Manual - page 10
OUTPOST Wireless Callbox
Field Programming
H
OW TO
F
IELD
P
ROGRAM
2-T
ONE
D
ECODE
(R
ECEIVE
) C
ODES
....
For special applications, it is desirable to program the Callbox for 2-Tone decode (receive) operation. The user is
able to field program the radio for one of the 9 pre-determined tone pairs specified in
Table 4
on page 11. These
tone pairs correspond to field programmable 2-Tone encode (transmit) codes available in other RITRON portable
and base radios. In our example we will program an RQX-456 to operate with 2-Tone decode (receive) frequen-
cies of 389.0 and 669.9 Hz.
NOTE: Field programming frequency and tone codes will remove all 2-Tone decode programming. If 2-Tone
decode operation is required, the 2-tone code must be re-programmed after field programming of the frequency
and tone codes.
94
1. Refer
to
Table 4
on page 11 to determine the two-digit code for 2-tone decode on 389.0
and 669.9 Hz and write it down.
2. Loosen the (4) captive screws in the front corners of the case. These screws are captive
to the housing; to prevent damaging them, DO NOT remove the screws from the hous-
ing.
3. Separate the case front from the case back, leaving the battery connected to the radio.
Make sure the unit has batteries installed.
NOTE: The voltage of the batteries must be greater than 6 VDC to program properly.
4. Press and release the ON/PTT button on the front of the unit to turn the radio on.
5. Press and hold the Program Button (See FIG-1 on page 4 for location). A "P" will appear
on the program display as you enter program mode and the radio will beep rapidly.
6. Release the program button after the beeping has stopped. The radio will display a se-
ries of six characters for Radio Identification, with each character separated by a hyphen.
The
1
st
two characters indicate the model number, the 3
rd
and 4
th
characters indicate the
radio type, and the 5
th
and 6
th
characters indicate the firmware revision.
MODEL NUMBER
RADIO TYPE
FIRMWARE REVISION
7. After the Radio Identification has been displayed the radio will emit a triple beep indicat-
ing that the radio is in program mode.
8. Enter the 1
st
digit of the 2-Tone code by clicking the Program button until the program
display shows the desired number. Pause—the radio will sound a low tone and show a
hyphen across the center of the display to indicate that it is ready to accept the next digit.
9. Enter the 2
nd
digit of the 2-Tone code by clicking the Program button until the program
display shows the desired number. Pause—the radio sounds a low tone and will show a
hyphen across the center of the display to indicate that it is ready to accept the next digit.
10. Press and release the ON/PTT button to save your programming. A triple beep will
sound to indicate that programming was successful and the radio will turn off.
NOTE: An error tone will sound if you attempt to save an incorrect code, an "E" will ap-
pear on the display and the radio will turn off. Check the digits you are attempting to en-
ter, then start over.
11. Turn the radio back on for normal operation.
8
Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at
www.ritron.com