Ritron “ 6 “ SERIES OUTPOST Owner's Manual - page 17
OUTPOST Wireless Callbox
PC Programming
I
NTERCOM
(A
LWAYS
O
N
) P
ROGRAMMING
(
CONTINUED
)
.............
Programming for Selective Calling:
2-Tone Paging Decode
This allows selective calling to a Callbox in a radio
system where there is more than one Callbox. When
the Callbox is programmed for 2-tone decode in
Intercom (Always-On) mode it will sound an alert tone
on the Callbox speaker, similar to a telephone ring
tone, whenever 2-tone has been successfully
decoded. This will alert any users in the immediate
area that there is an incoming call on the Callbox.
Ring Tone
Ring Tone must be set to sound the alert tone on the
Callbox speaker when a 2-Tone Page is successfully
decoded.
2-Tone Monitor Trip
This can be set when used with 2-Tone decode to
allow the Callbox to hear all radio traffic on the
channel after it has successfully decoded the correct
2-tone code, regardless of QC or DQC programming.
Normal conversation will follow after the 2-tone code is
decoded and the radio will automatically reset back to
2-tone decode after the RQX Reset Time has expired.
Switch Output Programming:
Switch on When Called
This will close the internal Switch Output whenever the
radio receives a call after an Inactivity Time that
exceeds the RQX Reset Time. The switch will remain
closed until the ON/PTT button is pressed or the RQX
Reset Time expires. The Switch Output could be used
to turn on a light or activate an alarm to notify users in
the area that an incoming call was present.
H
OW TO
S
EAL THE
A
NTENNA
..................................................
If the OUTPOST™ Callbox is to be used outdoors it is imperative
that the entire antenna connection be sealed with seal tape to
provide proper operation and prevent voiding warranty.
AF
Seal tape can be purchased at most Industrial Supply Stores,
Harware and Home Center Stores, or Electronic Supply Stores.
Regarless of the antenna used, it is always best to weatherproof
the antenna connection using seal tape.
Overlap
sealing tape
(1) inch be-
yond the
rigid section
of the an-
tenna
NOTICE
Failure to follow these instructions will cause damage to the
product, prevent proper sealing of the enclosure and will
void the Manufacturers Warranty.
Applying Seal Tape:
Wrap tape
from bottom,
sealing to
enclosure.
AFB-1545 Antenna
after sealing
1. Attach the antenna to the 50
Ω BNC connector on the
OUTPOST™ Callbox enclosure.
2. Begin wrapping seal tape at the base of the antenna connector
such that it is sealed to the enclosure top.
3. Overlap the seal tape as you tightly wrap upward around the
connector and antenna. Continue to overlap seal tape around
the connector base, past the articulated portion of the antenna
and several inches up the thin, shiny section of the antenna.
B-1545 Antenna
before sealing
Have questions? Call 800-USA-1-USA (800-872-1872) or visit our website at www.ritron.com
15