Rittal SK 3201.200 Assembly And Operating Instructions Manual - 7 Device Mounting
10
Rittal Thermoelectric Cooler assembly and operating instructions
7 Device mounting
GB
7.1 External mounting
When the cooling unit is mounted as externally-
mounted variant, the supplied self-adhesive sealing
tape must be fastened on the device rear wall of the
cooling unit so that no gaps result at the joint edges.
Then screw the supplied studs into the blind nuts at
the rear of the unit. Secure the cooling unit using the
supplied washers and nuts.
Fig. 8:
Position of the sealing tape
Fig. 9:
Fastening the cooling unit
Fig. 10:
External and internal mounting
Fig. 11:
Permissible mounting positions
7.2 Internal mounting
For the full internal mounting of the cooling unit, the
louvred grille must be carefully removed from the de-
vice. The self-adhesive sealing tape supplied must
be placed on the front of the cooling unit (the device
face from which the louvred grille has been re-
moved) so that no gaps result at the joints. Then
screw the supplied studs into the blind nuts at the
front of the unit. Secure the cooling unit using the
supplied washers and nuts. To complete the mount-
ing, the louvred grille must be re-attached.
Fig. 12:
Position of the sealing tape
Fig. 13:
Fastening the cooling unit
125
400
400
155
55
100
100
55
Internal mounting
External mounting
External
mounting,
vertical
External
mounting,
horizontal
Internal
mounting,
horizontal
Internal
mounting,
vertical
max. 45°
max. 45°
max. 45°
max. 45°