RJM Amp Gizmo User Manual - Bank Selection

Bank Selection 

The Amp Gizmo can store programs in MIDI banks 0 and 1, for a total 

of 256 programs. Continuous Controller #0 (Bank MSB) is used to 

select the current MIDI bank. Bank numbers above bank 1 are ignored. 

Backing Up Your Settings: Sysex Dump  

A Sysex (System Exclusive) data dump will send the current A

MP 

G

IZMO

 system configuration out through the MIDI Thru/Out port. You 

can then save this data to your computer, or copy the settings directly to 

another A

MP 

G

IZMO

. 

Hold down the Switch 5 button while powering up the A

MP 

G

IZMO

, and 

the A

MP 

G

IZMO

 will immediately send the Sysex Dump. It only takes a 

couple of seconds to complete. 

If you wish to copy settings from one A

MP 

G

IZMO

 to another, connect 

the MIDI Thru/Out of the transmitting unit to the MIDI Input of the 

receiving unit, then power up the transmitting unit while holding down 

the Switch 5 button. (Note that the receiving A

MP 

G

IZMO

 must be in 

normal operating mode to receive data.) The receiving unit will display 

a progress bar graph on the LEDs. The transfer goes very quickly, 

taking only a couple of seconds. In the case of an error, the receiving 

unit will flash all LEDs 5 times. 

Once the transfer completes, the receiving unit will reset, then return to 

normal operating mode. The receiving unit now has an exact copy of 

the transmitting unit’s settings. 

7