RJM MasterMind User Manual - page 18
12
Bank Up - In Preset Setup, increments the current preset number by 1. Also used as the “Yes” button when the
MasterMind is asking a Yes/No question.
Global Setup
When you enter Setup Mode for the first time, the first thing you’ll likely want to do is enter Global Setup. Global Setup
allows you to define which devices are connected to the MasterMind and what types of messages are sent to them. You
do this by setting Program Change and Continuous Controller destinations. There are four Program Change
destinations, labeled PC1 through PC4, and eight Continuous Controller destinations labeled CC1 through CC8.
Each Program Change destination can be set to any MIDI channel (or none). Each destination typically corresponds to
one MIDI device. For example, PC1 could be set to the MIDI channel of your RJM RG-16, PC2 could be set to the MIDI
channel of one MIDI-enabled effects processor, and PC3 could be set to the MIDI channel of a second MIDI-enabled
effects processor. Note that you only set MIDI channels here. In
Preset Setup
(see next section), you will define the
program number that’s sent to each Program Change destination for each preset.
Each Continuous Controller destination is set to a particular MIDI channel and controller number. These destinations
can be set to be Continuous Controllers on multiple MIDI devices, or they can all be on the same device, each
controlling a different parameter. Once the MIDI channel and controller number is set in Global Setup, you can set each
controller’s value for each preset using
Preset Setup
.
Entering Global Setup
Once you’ve entered
Setup Mode
, pressing the Function/Global Select button puts you into Global Setup. The green
LED above the button will light to tell you that Global Setup is active. You are now ready to edit the first parameter.
Watching the display, you’ll see that it alternates between displaying PC1 and CH01. It’s telling you that the first
Program Change destination is set to MIDI channel 1. The LED above the 5 / MIDI Ch button will be lit, indicating that it
is active and can be used to change the MIDI channel. Pressing this button will increment the MIDI channel by 1, until it
reaches 16 (the maximum). Pressing it again will change it to read CH--, which means no MIDI message will be sent to
this Program Change destination. Pressing the button again will set the channel back to the minimum, which is CH01.
All the other Global parameters can be edited in this way. Pressing the Function / Global Select button will move you
to the next parameter. Once you reach the end of the parameter list, pressing Function / Global Select will bring you
back to the first parameter in the list.
The Global parameters are as follows:
PC1 - Program Change Destination #1
(MIDI Ch range: CH01 - CH16, CH-- (PC1 disabled) , Default value: CH01 )
Sets the MIDI channel for the first Program Change destination. Press 5 / MIDI Ch to select the MIDI Channel.
PC2 - Program Change Destination #2
(MIDI Ch range: CH01 - CH16, CH-- (PC2 disabled) , Default value: CH-- )
Sets the MIDI channel for the second Program Change destination. Press 5 / MIDI Ch to select the MIDI Channel.
PC3 - Program Change Destination #3
(MIDI Ch range: CH01 - CH16, CH-- (PC3 disabled) , Default value: CH-- )
Sets the MIDI channel for the third Program Change destination. Press 5 / MIDI Ch to select the MIDI Channel.
PC4 - Program Change Destination #4
(MIDI Ch range: CH01 - CH16, CH-- (PC4 disabled) , Default value: CH-- )
Sets the MIDI channel for the fourth Program Change destination. Press 5 / MIDI Ch to select the MIDI Channel.