RJM MasterMind User Manual - page 20
14
The LED above the 2 / Program/CC Number button will be lit, indicating that it can be used to change the program
number. Pressing this button will increment the program number by 1, until it reaches 128 (the maximum). Pressing it
again will set the program number back to the minimum, which is =001.
(Important Note: Some MIDI devices use program numbers 1 through 128 and some use program numbers 0 through
127. If your device is one of the latter, your program numbers will be off by 1. Selecting program 1 on the MasterMind
will cause the device to select program 0. Selecting program 2 on the MasterMind will cause the device to select
program 1, etc.)
All the other Preset parameters can be edited in this way. Pressing the 1 / Function Select button will move you to the
next parameter. If a parameter has been disabled in Global Setup (for example if PC2 is set to CH--), it will not appear in
Preset Setup. Once you reach the end of the parameter list, pressing 1 / Function Select again will bring you back to
the first parameter in the list.
The Preset parameters are as follows:
PC1 - Program Change #1
(Program Change number range: =001 - =128, =--- (send no PC), Default value: preset 001 defaults to =001,
preset 002 defaults to =002, preset 003 defaults to =003 etc. )
Sets the program number for the first Program Change destination. Press 2 / Program/CC Number to select the
program number.
PC2 - Program Change #2
(Program Change number range: =001 - =128, =--- (send no PC), Default value =001)
Sets the program number for the second Program Change destination. Press 2 / Program/CC Number to select the
program number.
PC3 - Program Change #3
(Program Change number range: =001 - =128, =--- (send no PC), Default value =001)
Sets the program number for the third Program Change destination. Press 2 / Program/CC Number to select the
program number.
PC4 - Program Change #4
(Program Change number range: =001 - =128, =--- (send no PC), Default value =001)
Sets the program number for the fourth Program Change destination. Press 2 / Program/CC Number to select the
program number.
FunC - Function Button
(MIDI Ch range: CH01 - CH16, CH-- (Function button disabled) , Default value: CH01)
(CC number range: c000 - c127, Default value: c000)
Sets the Continuous Controller message sent by the Function button for this preset. If bank support is enabled (see
Global Setup
), c000 will be displayed instead as ban (bank). Setting this parameter to ban will enable the Alternate
Preset feature for this preset (see
Alternate Presets
section). Setting it to any other value will cause normal Continuous
Controller messages to be sent. Press 2 / Program/CC Number to select the Continuous Controller number, press 5 /
MIDI Ch to select the MIDI Channel.
PDL -
Expression Pedal
(MIDI Ch range: CH01 - CH16, CH-- (Expression pedal disabled) , Default value: CH01)
(CC number range: c000 - c127, Default value: c007)
Sets the Continuous Controller message sent by the Expression Pedal for this preset. Press 2 / Program/CC Number to
select the Continuous Controller number, press 5 / MIDI Ch to select the MIDI Channel.
CC1 - Continuous Controller #1
(CC value range: =000 - =127, =--- (send no CC), Default value: 000)
Sets the value for the first Continuous Controller destination. Press 4 / CC Value to set the value, or press 3 / CC On/Off
to quickly toggle between the most commonly used values: =000 and =127.