1. DL manuals
  2. Ro-Man
  3. Water System
  4. 200 GPD
  5. Installation Manual

Ro-Man 200 GPD Installation Manual

Other manuals for 200 GPD: Installation manual
Manual is about: Ro-Man Reverse Osmosis System Installation Guide 200 AND 300 GPD Systems

Summary of 200 GPD

  • Page 1

    R o -man reverse osmosis system installation guide for 200, 300 & 450 gpd ro systems standard installation kit contents: reverse osmosis system membranes sediment filter carbon filter multi media filter 2 metres red pipe 2 metres blue pipe waste saddle saddle valve mains ¼” roll ptfe tape filter wre...

  • Page 2: Conditions For Operation

    Conditions for operation source water supply - tec community / private non-chlorinated – or chlorinated as long as the carbon filter is in place and replaced every 6 months or after recommended gallon throughput, which comes first. Membranes are damaged by chlorine. System pressure (pre-filtration) ...

  • Page 3: Fitting The Membrane

    Note on fit connections / quick connectors: the push fit connectors are opened by pushing down on the collet ring with two fingernails and pulling the hose at the same time. If your nails are not user friendly, then use a pair of pliers, a small spanner or any tool that can apply pressure on both si...

  • Page 4: Maintenance

    Fitting the pipes for production red: feed water – this goes to the metal saddle valve (the system has a red cap on the push fit fitting). Green: - waste water – this goes to the plastic waste saddle from the out on the membrane housing (the system has a green cap on the push fit fitting). Blue: - p...

  • Page 5: Troubleshooting

    Troubleshooting it's ok to contact your retailer or send ro-man an email via helpdesk@ro-man.Com . It is best to try first and remember, we cannot see it from here digital photos are great. All problems are fixable and in general they will show up in the first 24-48 hours after the system is fully c...

  • Page 6: Ro-Man Options

    Ro-man options pressure gauge there are two reasons for fitting a pressure gauge: 1. To read the water pressure in order to check whether it is within specification. System pressure is very important too little pressure will make the production rate very slow and too much pressure will make the seal...

  • Page 7

    How do you know how pure your water is when using a ro system? We measure how well ro systems work with a total dissolved solids (tds) meter, with measuring how well your water filter is running you are going through the process of making pure water without knowing if it is actually pure.. Total dis...

  • Page 8

    Ro-man thin film membrane information permeate flow rate minimum salt stabilized salts gals/day us litres/day rejection (%) rejection (%) 100 380 96 98 75 283 96 98 50 189 96 98 36 136 96 98 dimensions l i d inches cm inch cm inches cm 11.63 295 10.0 250 1.8 46 recommended operation conditions maxim...

  • Page 9: Net Pressure Correction

    Page 9 of 10 example question: if a thin-film membrane permeate rate at 77 degrees fahrenheit = 100 gallons/day. What is the permeate rate at 59 degrees fahrenheit? Answer: temperature correction factor (from table above) = 1.47permeate flow at 59 degrees fahrenheit = 100÷1.47 = 68.03 gallons (us)/d...

  • Page 10: -Man

    Page 10 of 10 r o -man for assistance and enquiries please contact the support team: helpdesk@ro-man.Com or telephone 018236 98813.