Road Angel 6000 User Manual - 7. Getting There
36
7. Getting There
When you have specified your route, and tapped on the Navigation or
Start Navi buttons, ROAD ANGEL Navigator switches to the full screen
Guidance mode. It then provides you with on-screen and audio directions
to get you to your destination.
Normally, the screen shows your speed in a box on the left-hand side (see
the picture on page 38). If you tap on this box, route information (your
speed, the current time, estimated time of arrival, the distance to your
destination and GPS status information) is displayed instead. After 20
seconds, or if you tap on the box again, the speed display is restored.
Tap on the screen to browse across the map. Tap on the Satellite button to
return to Guidance mode.
If you want to cancel the route guidance instructions and return to
map mode (see page 18), click on the Cancel button.
If you want to make changes to your route or change any other
settings, tap on the Menu button. The following menu is shown:
Name of next
road
Current position
(shown by cross
hairs)
Distance to next
turn
Route (shown in
blue – direction of
one-way roads
shown in red)
Speed/Route
information
box (see below)